Camera installation, Preparing the camera, Preparing the mounting surface – Honeywell EQUIP HD3MDIHX User Manual

Page 18: Figure 2-2, Surface mounting template

Advertising
background image

18

Installation and Setup

Camera Installation

Preparing the Camera

1. Rotate the dome bubble counterclockwise

until it disconnects.

2. Pull the turret to remove it.
3. Rotate the camera counterclockwise until it

disconnects from the skirt.

4. Set aside the dome bubble, turret, and

camera.

Preparing the Mounting Surface

1. Mark the mounting surface for screw holes and wire access hole.

Use the mounting template if you are surface mounting your camera. See

Surface

Mounting Template

on page

65

Use the flush mount adapter plate as a template if you are flush mounting your
camera.

Figure 2-2

Surface Mounting Template

Skirt

Dome bubble

Camera

Turret

Drill these holes for the
mounting screws.

Cut this hole, then pull the
power, audio, and alarm
wires through it.

Advertising
This manual is related to the following products: