Husqvarna 132R - Manual (Page 15)

English – 15
ASSEMBLY
Cable adjustment
• Throttle cable should be paralleled to flexible shaft. In
case of twisting, they should be restored by parallel.
• Throttle cable should be adjusted under the bended
flexible shaft.
1 Loosen the lock-nut (C) and adjust the cable adjuster
sleeve (D) so the stop on the carburettor throttle cam just
contacts the throttle stop and the cable position keep 1–2
mm play between cable lug and slotted fittings when the
throttle trigger is fully depressed.
2 When the throttle cable is adjusted correctly, tighten the
locking nut (C).
Adjusting the harness and clearing
saw
Standard harness
Quick release
At the front is an easily accessible, quick release. Use this if
the engine catches fire or in any other emergency situation
that requires you to free yourself from the machine and
harness.
Spreading the load on your shoulders
A well-adjusted harness and machine makes work much
easier. Adjust the harness for the best working position.
Tension the side straps so that the weight is evenly distributed
across both shoulders.
Correct height
Adjust the shoulder strap so that the cutting attachment is
parallel to the ground.
Correct balance
Let the cutting attachment rest lightly on the ground. Adjust
the position of the support hook to balance the clearing saw
correctly.
!
WARNING! When using a clearing saw it
must always be hooked securely to the
harness. Otherwise you will be unable to
control the clearing saw safely and this can
result in injury to yourself or others. Never
use a harness with a defective quick release.
1-2mm