Honeywell TN924W - Manual (Page 21)

41
RAIN WINDOW
The Weather Station records a current the total amount of the rainfall for the last hour,
24 hours, past day, past week and the past month. The rainfall can be displayed in
inches or mm.
The daily rainfall can be programmed to alert you if the rainfall exceeds a
pre-programmed limit.
ACCESSING RAIN WINDOW
Press UP or DOWN until the RAIN icon on the display starts flashing.
VIEWING RAIN STATISTICS
In the Rain Window press either SET or MEM button to recall:
• Current rainfall
• Rain for the last hour
• Rain for the last 24 hours,
• Yesterday rain
• Last week
• Last month.
Tip: For the rain rate estimate the Last Hour rainfall value is understood as “inch/hr” or
“mm/hr”.
PROGRAMMING RAINFALL AMOUNT UNITS
In the Rain Window, press and hold SET button to program the rainfall units in mm or
inches.
RESETTING RAIN STATISTICS MEMORY
In the Rain Window, press and hold MEM to reset all rainfall statistics.
ACTIVATING OR DEACTIVATING RAIN ALARM
• In the Rain Window press ALARM/CHART button to display either the current
rainfall or the daily rainfall alarm (with “ALARM HI” displayed)
• If the rain alarm is disabled, the abbreviation “OFF” will be displayed; otherwise
the rainfall alarm amount will be shown
• When the rainfall alarm amount is displayed, press UP to activate or DOWN to
deactivate
PROGRAMMING DAILY RAINFALL ALARM
• In the Rain Window, press ALARM/CHART to display the rainfall alarm
• Press and hold ALARM/CHART until the “ALARM HI” will flash
• Set the desired amount for the rainfall alarm using UP or DOWN buttons. Press
42
and hold either button for fast digits advance.
• Press ALARM/CHART to confirm selection and the unit will return to the
rainfall alert display.
WIND WINDOW
The front portion of the Wind Window shows wind direction in animated compass display.
The wind direction can be displayed as compass point (i.e. NW) or in bearing starting
from the North (i.e. 22.5º).
The upper left section of the Wind Window can be programmed to display either a
temperature at the place of anemometer or the temperature adjusted to the wind chill
factor.
The lower left section of the Wind Window indicates the average wind speed for the past
10 minutes, as well as gust, high wind speed and gust alarm information. It can also
show records of the maximum wind speed and wind gust collected during the day.
The wind speed and gust can be programmed to alert you if the wind speed or gust
exceeds a pre-set limit. The wind speed can be displayed in km/h, mph, m/s or knots.
ACCESSING WIND MODE
Press UP or DOWN until the WIND icon on the Weather Station display starts flashing.
OPERATING WIND WINDOW
In the Wind Window press the SET button to recall:
• Wind chill temperature with wind direction in bearings
• Wind chill temperature with a wind direction in compass points
• Temperature at anemometer and wind direction in compass points
• Temperature at anemometer and wind direction in bearings
PROGRAMMING WIND SPEED UNITS
In the Wind Window, press and hold SET to set the wind speed units in km/h, mph, m/s
or knots.
VIEWING WIND STATISTICS
In the Wind Window, press the MEM button to recall:
• Current wind speed
• Daily maximum wind speed with “DAILY MAX” displayed
• Wind gust speed with a “GUST” displayed
• Daily maximum gust speed with a “GUST DAILY MAX” displayed
RESETTING WIND STATISTICS MEMORY
In the Wind Window, press and hold MEM to reset all wind statistics memory.