HP LE1911I - Manual (Page 19)

Installing an HP Thin Client on the Stand
You can install an HP USDT or Thin Client computer on the rear side of the stand. This section provides
instructions on installing the Thin Client.
1. On the rear of the stand, remove the two screws (1) from the top of the computer mounting bracket
and lift the bracket off the stand (2).
Figure 3-11 Removing the Computer Mounting Bracket
2. Remove the HP logo panel from the right side of the Thin Client to access the screw holes for the
computer mounting bracket.
Figure 3-12 Removing the HP Logo Panel
ENWW Installing an HP Thin Client on the Stand 11