Hoshizaki SELF-CONTAINED CRESCENT CUBER KM-250BAF - Manual (Page 13)

13
6. Startup
CAUTION
1. All parts are factory-adjusted. Improper adjustments may result in failure.
2. If the unit is turned off, wait for at least 3 minutes before restarting the
icemaker to prevent damage to the compressor.
1) Open the water supply line shut-off valve.
2) Remove the front panel.
3) Move the control switch on the control box, to the “ICE” position.
4) Run the icemaker for about 10 minutes, and move the switch to the “OFF” position.
5) Open the door.
6) Remove the plug at the bottom of the water tank to drain the water tank. See Fig. 2.
7) Replace the plug in its correct position.
8) Clean the storage bin.
9) Move the switch to the “ICE” position, and start the automatic icemaking process.
10) Replace the front panel in its correct position.
11) Shut the door.