Hand Held Products QUICK CHECK 890 - Manual (Page 19)

Quick Check® 890 User’s Guide 3 - 1
3
Using the Quick Check 890 Verifier System
Scanning a Bar Code Symbol Using the QC890 Verifier
Note: Calibration is a requirement of the ISO/IEC standards. Without proper
initial calibration, the values displayed may not be accurate. Please be
sure to calibrate the QC890 Verifier prior to scanning bar codes and when
you change apertures and/or external scanning devices.
1. Place the QC890 Verifier on top of the symbol.
2. Press the scan button on top of the unit to turn on illumination. Look through
the unit’s window to align the unit with the bar code.
Note: The best verification data is gathered by aligning the center of the symbol
to the center arrows.
3. Press the scan button on top of the unit again while the illumination is on to
scan and verify the bar code.
Scanning a Bar Code Symbol Using
Quick Check ImageData
A scan can be initiated with Quick Check ImageData.
1. Place the QC890 Verifier on top of the symbol.
2. If necessary, press the scan button on top of the unit to turn on illumination to
aid in alignment of the symbol.
3. For the PC version, click the Scan button on the Main Display window.