Hand Held Products QUICK CHECK 890 - Manual (Page 25)

Quick Check® 890 User’s Guide 3 - 7
The Calibration Log looks like this:
Reflectometer Mode
Note: The Reflectometer Mode is only available for use with the mouse/pen
wands.
Reflectometer Mode measures the spot reflectance of the area at which the
imager is “looking.”
1. To activate the Reflectometer, click on the Reflectometer icon ( ) on the
tool bar below the menu options. The Reflectometer window opens.
2. Place the scanning device on any surface to see the spot reflectance of that
surface. The green status bars shows the reflectance signal strength. The
field to the right of the status bar shows the percentage of reflectance.
3. Select OK to exit the Reflectometer mode.