Document Outline

• STC-15W04
• Revision History
• Preface
• Table of Contents
• List of Figures
• List of Tables
• 1 Introduction
  • 1.1 Overview
  • 1.2 Features
  • 1.3 Package Contents
  • 1.4 Block Diagram
  • 1.5 Mechanical Dimensions
• 2 System Description
  • 2.1 Specifications
  • 2.2 I/O Panel Layout
    • Bottom View
    • Rear View
  • 2.3 Pin Definitions
    • RJ-45 Gigabit Ethernet Connectors
    • USB Connector
    • RS-485 Port (isolated)
    • CFast Socket
    • DC Power Input Connector
• 3 Getting Started
  • 3.1 Panel Mounting
  • 3.2 Connecting Power
  • 3.3 CFast Card Installation
  • 3.4 CMOS Battery Replacement
• 4 BIOS
  • 4.1 Introduction
  • 4.2 Starting the BIOS
    • Setup Menu
    • Navigation
    • Hotkey Descriptions
  • 4.3 Main Setup
    • System & Board Info
  • 4.4 Advanced BIOS Setup
    • Watchdog Timer Timeout
    • 4.4.1 PCI Subsystem Settings
      • PCI Latency Timer
      • VGA Palette Snoop
      • PERR# Generation
      • SERR# Generation
    • 4.4.2 CPU Configuration
      • Hyper-Threading
      • Execute Disable Bit
      • Limit CPUID Maximum
    • 4.4.3 Thermal Configuration
      • CPU Thermal Configuration
      • DTS SMM
      • Platform Thermal Configuration
      • Critical Trip Point
      • Active Trip Point Lo Fan Speed
      • Active Trip Point Hi Fan Speed
      • Passive Trip Point
      • Passive TC1 Value
      • Passive TC2 Value
      • Passive TSP Value
    • 4.4.4 IDE Configuration
      • SATA Controller(s)
      • Configure SATA as
      • Port0 Speed Limit
      • Port1 Speed Limit
      • SATA Port 0
      • SATA Port 0 Hot Plug
      • SATA Port 1
      • SATA Port 1 Hot Plug
    • 4.4.5 USB Configuration
      • Legacy USB Support
      • EHCI Hand-off
      • USB transfer time-out
      • Device reset time-out
      • Device power-up delay
    • 4.4.6 Super IO Configuration
      • Serial Port 1 Configuration
      • Change Settings
    • 4.4.7 IT8781F Hardware Monitor
    • 4.4.8 PPM Configuration
      • EIST
      • CPU C state Report
      • Enhanced C state
      • CPU Hard C4E
      • CPU C6 state
      • C4 Exit Timing
      • C-state Popdown
      • C-state Popup
  • 4.5 Chipset Configuration
    • 4.5.1 Host Bridge Configuratio
      • MRC Fast Boot
      • Max TOLUD
      • IGFX - Boot Type
      • LCD Panel Type
      • Panel Scaling
      • Active LFP
      • Fixed Graphics Memory
    • 4.5.2 South Bridge Configuration
      • Restore AC Power Loss
      • Azalia Controller
      • Select USB Mode
      • UHCI #1 (ports 0 and 1)
      • UHCI #2 (ports 2 and 3)
      • UHCI #3 (ports 4 and 5)
      • UHCI #4 (ports 6 and 7)
      • USB 2.0(EHCI) Support
      • SMBus Controller
  • 4.6 Boot Settings
    • Setup Prompt Timeout
    • Bootup NumLock State
    • Quiet Boot
    • Fast Boot
    • Skip VGA
    • Skip USB
    • Skip PS2
    • GateA20 Active
    • Option ROM Messages
    • Interrupt 19 Capture
    • CSM Support
    • Boot Option Priorities
  • 4.7 Security Setup
    • Administrator, User Password
  • 4.8 Save & Exit Menu
    • Save Changes and Exit
    • Discard Changes and Exit
    • Save Changes and Reset
    • Discard Changes and Reset
    • Save Changes
    • Discard Changes
    • Restore Defaults
    • Save as User Defaults
    • Restore User Defaults
    • Launch EFI Shell from file system device
• Important Safety Instructions
• Getting Service