Document Outline

• mn_mencapedc_revA.pdf
  • COVER
  • Errata A. Changes to 4.2.10 Route Statistics
  • TABLE OF CONTENTS
  • LIST OF FIGURES
  • PREFACE
    • Customer Support
    • About this Manual
      • Reporting Comments or Suggestions Concerning this Manual
    • Related Documents
    • Conventions and References
      • Cautions and Warnings
      • Metric Conversion
      • Recommended Standard Designations
      • Trademarks
    • Electromagnetic Compatibility (EMC) Compliance
      • Emissions Compliance
      • EN61000 Compliance
    • Safety Compliance
      • EN60950
      • Low Voltage Directive (LVD)
    • Warranty Policy
      • Limitations of Warranty
      • Exclusive Remedies
  • Chapter 1. INTRODUCTION
    • 1.1 Introduction
    • 1.2 Standard Features
    • 1.3 Performance
    • 1.4 MENCAP Redundancy (CME-5100 & CME-5110)
      • 1.4.1 Introduction
      • 1.4.2 Configuration
      • 1.4.3 Operation
    • 1.5 Specifications
    • 1.6 Terminology
  • Chapter 2. INSTALLATION & INITIAL CONFIGURATION
    • 2.1 Major Assembly
    • 2.2 Unpacking
    • 2.3 Installation
      • 2.3.1 Standalone Installation
      • 2.3.2 Redundancy Installation
    • 2.4 Initial Configuration
      • 2.4.1 Standalone Configuration
      • 2.4.2 Redundancy Configuration
  • Chapter 3. INTERFACE PINOUTS
    • 3.1 Introduction
    • 3.2 MENCAP 50 (CME-5000 and CME-5010)
      • 3.2.1 DC Power
      • 3.2.2 RJ-12 Terminal
      • 3.2.3 RJ-12 Redundancy
      • 3.2.4 RJ-45 Ethernet
      • 3.2.5 BNC ASI (Out-A and Out-B)
    • 3.3 CME-1600 Redundancy Switch
      • 3.3.1 DC Power
      • 3.3.2 BNC ASI (Typical Out-A and Out-B)
      • 3.3.3 RJ-12 Primary Redundancy
      • 3.3.4 BNC Primary ASI (Typical In-A and In-B)
      • 3.3.5 RJ-12 Secondary Redundancy
      • 3.3.6 BNC Secondary ASI (Typical In-A and In-B)
  • Chapter 4. DEVICE MANAGEMENT VIA USER INTERFACES
    • 4.1 Introduction
    • 4.2 Web Interface
      • Administrative Configuration
      • 4.2.2 Network Configuration
      • 4.2.3 Egress Configuration
      • 4.2.4 PSI Configuration
        • 4.2.4.1 Option DVB-C NIT Submenu
        • 4.2.4.2 Option DVB-S NIT Submenu
        • 4.2.4.3 Option DVB-T NIT Submenu
      • 4.2.5 SMPTE-325M Configuration
      • 4.2.6 Route Configuration
      • 4.2.7 Advanced Route Configuration
      • 4.2.8 IGMP Configuration
      • 4.2.9 Redundancy Configuration
      • 4.2.10 Route Statistics
    • 4.3 Terminal Interface
      • 4.3.1 Main Menu
      • 4.3.2 Redundancy Configuration Menu
      • 4.3.3 Administration Menu
        • 4.3.3.1 Port Number Configuration
      • 4.3.4 Stats Menu
        • 4.3.4.1 Route Stats Menu
        • 4.3.4.2 Ethernet Stats Menu
        • 4.3.4.3 DMA Stats Menu
      • 4.3.5 Egress Configuration Menu
      • 4.3.6 Network Configuration Menu
      • 4.3.7 SMPTE 325M Configuration Menu
      • 4.3.8 Route Configuration Menu
        • 4.3.8.1 Advanced Route Configuration Menu
      • 4.3.9 PSI Configuration Menu
      • 4.3.10 IGMP Configuration Menu
    • 4.4 Telnet Interface
    • 4.5 Trivial File Transfer Protocol (TFTP)
    • 4.6 Simple Network Management Protocol (SNMP)
  • Appendix A. SOFTWARE UPGRADE
    • A.1 Introduction
    • A.2 Web Interface
    • A.3 Telnet or Terminal Interface
  • Appendix B. IP ROUTING SUPPORT
    • B.1 Introduction
    • B.2 Route Configuration
      • B.2.1 Unicast Routing
      • B.2.2 Multicast Routing
    • B.3 802.1Q VLAN Support
    • B.4 Section Packing
    • B.5 1,024 Routes
    • B.6 10,000 Routes
    • B.7 Multicast Zones
    • B.8 IP Copy
    • B.9 Quality of Service (QoS)
    • B.10 MPE/IP
  • Appendix C. MENCAP 50 PRIVATE MIB ELEMENTS
    • C.1 Admin Menu
    • C.2 Network Menu
    • C.3 Egress Menu
    • C.4 PSI Menu
      • C.4.1 DVB-C NIT
      • C.4.2 DVB-S NIT
      • C.4.3 DVB-T NIT
    • C.5 SMPTE-325M Menu
    • C.6 Routing Table
    • C.7 Advanced Routing Table
    • C.8 IGMP Menu
    • C.9 Redundancy Menu
    • C.10 Statistics Table
  • Appendix D. TROUBLESHOOTING
  • METRIC CONVERSIONS