Document Outline

• KST-2000L Rev 2
• Customer Support
• Table of Contents
  • Overview of Changes to Previous Edition
  • About this Manual
    • Conventions and References
    • Reporting Comments or Suggestions Concerning this Manual
  • EMC Compliance
    • EN55022 Compliance
    • EN50082-1 Compliance
    • Federal Communications Commission (FCC)
    • Safety Compliance
    • EN 60950
    • Low Voltage Directive (LVD)
  • Warranty Policy
    • Limitations of Warranty
    • Exclusive Remedies
    • Disclaimer
• Chp. 1 Introduction
  • Description
    • Areas of Operation:
    • Transmit and Receive Band Coverage
    • Features
    • KST-2000L System
• Chp. 2 Specifications
  • Summary of Specifications
    • Solid-State Power Amplifier (SSPA)
    • Interface Requirements
    • Internal Data Interface
  • Size and Weight Specifications
  • Environment Specifications
  • CE Certification
  • Terminal Assemblies
• Chp. 3 Connector Pinouts
  • System Equipment Information
    • System Components
    • Description of Options
    • Spare Parts
  • Electrical Connections
    • Converter Unit
• Chp. 4 Operation
  • Initial Setup
    • Uplink Setup
    • Downlink Setup
  • Monitor and Control (M&C)
  • Up Converter Description
  • L-Band to IF Down Converter Description
  • Automatic Gain Control (AGC)
    • Operation
    • Fault and Error Response
    • Manual Gain Operation
• Chp. 5 Fault Indication and Isolation
  • Fault Indication
  • Fault Isolation
  • Stored Faults
• Chp. 6 Equipment Mounting
  • Tools Required
  • Converter Unit Installation
    • Spar Arm Mount
    • Pole Mount
  • SSPA Installation
    • Feed Mount Offset Antenna
  • LNB Installation
    • Feed Mount Offset Antenna
  • Cable Installation
• Chp. 7 Terminal Mode Commands
  • General
  • Message Structure
    • Start Character
    • Device Address
    • Command/Response
    • End Character
  • System Configuration Commands
  • HPA Commands
  • LNB Commands
  • System Communications Commands
  • 7.7Miscellaneous Commands
  • 7.8Fault Commands
  • 7.9Burst Control Mode
• Appendix A. Outline Drawings
  • 2 and 4 Watt SSPA Equipment Outline
  • KST-2000L Converter Equipment Outline
  • A.3Ku-Band LNB Equipment Outline
• Back Cover