Document Outline

• SNM-1001 Rev. 1 Cover
• Table of Contents
  • About this Manual
    • Conventions and References
    • Reporting Comments or Suggestions Concerning this Manual
  • European EMC Directive
  • Warranty Policy
    • Limitations of Warranty
    • Exclusive Remedies
    • Disclaimer
• Customer Support
• CHP1 INTRODUCTION
  • Overview
  • Mode of Operation
    • Description
  • Options
  • Specifications
• CHP2 INSTALLATION
  • Unpacking
  • System Installation
  • External Modem Connectors
    • DATA I/O Interface (J8)
    • Remote (J6)
    • Faults (J7)
    • TX IF Output (CP1)
    • RX IF Input (CP2)
    • AC Power
    • DC Power
    • Chassis GND
    • AGC Test Point
• CHP3 OPERATION
  • Front Panel
    • LED Indicator
    • Front Panel Keypad Option
  • Clocking Options
• CHP4 THEORY OF OPERATION
  • Modulator
    • Specifications
    • Theory of Operation
  • Demodulator
    • Specifications
    • Theory of Operation
    • Viterbi Decoding Theory
  • Monitor and Control
    • Non-Volatile Memory
    • Remote Interface Specification
    • M&C Theory of Operation
    • Remote Interface Configuration
    • Modem Defaults
  • Digital Interfaces
    • EIA-422/449 Interface
• CHP5 MAINTENANCE
  • System Checkout
    • Modulator Checkout
    • Demodulator Checkout
    • Test Points
  • Fault Isolation
    • Modulator Faults
    • Demodulator Faults
    • Transmit Interface Faults
    • Receive Interface Faults
    • Common Equipment Faults
  • Module Identification
  • Software Versions
  • Repackaging Requirements for Shipment
• Appendix A REMOTE CONTROL OPERATION
  • General
  • Message Structure
    • Start Character
    • Device Address
    • Command/Response
    • End Character
  • Configuration Commands/Responses
    • Modulator
    • Demodulator
    • Interface
    • System
    • AUPC
  • Status Commands/Responses
    • Configuration
    • Error Performance
  • Stored Faults
• Glossary
• Index