Document Outline

• CD-turboIP-G2_r2.pdf
  • INSIDE COVER
  • TABLE OF CONTENTS
  • FIGURES
  • PREFACE
    • About this Manual
      • Reporting Comments or Suggestions Concerning this Manual
    • Conventions and References
      • Warnings, Cautions, and Notes
      • Metric Conversion
      • Recommended Standard Designations
      • Trademarks
    • Safety Compliance
      • EN 60950 Electrical Safety and Compliance
      • European Low Voltage Directive (LVD) (2006/95/EC)
    • Electromagnetic Compatibility (EMC) Compliance
      • EN 55022 – 1997 Compliance
      • EN 50082-1 – 1997 Compliance
      • Federal Communications Commission (FCC)
    • End User License Agreement (EULA)
    • End User License Agreement (EULA) Copy Protection
    • Warranty Policy
      • Limitations of Warranty
      • Exclusive Remedies
    • Customer Support
      • Contact Comtech EF Data for:
      • Contacting Comtech EF Data
      • Returning a Product for Upgrade or Repair
  • Chapter 1. INTRODUCTION
    • 1.1 Overview
      • 1.1.1 Key Operational Features
    • 1.2 Features
      • 1.2.1 Physical Description
        • 1.2.1.1 Major Assemblies (Standard and Optional)
      • 1.2.2 Dimensional Envelopes
      • 1.2.3 Physical Features
        • 1.2.3.1 Front Panels
        • 1.2.3.2 Rear Panels
      • 1.2.4 Acceleration and WAN Optimization
        • 1.2.4.1 TCP/IP Performance Limitations
        • 1.2.4.2 TCP/IP Performance Enhancement Proxy
        • 1.2.4.3 Selective Acceleration
        • 1.2.4.4 Data and Header Compression
        • 1.2.4.5 Minimum Compression Ratio
    • 1.3 Software Update
    • 1.4 FAST System
      • 1.4.1 FAST System Theory
      • 1.4.2 FAST Implementation
      • 1.4.3 FAST Accessible Options
    • 1.5 Remote Control
    • 1.6 Summary of Specifications
  • Chapter 2. INSTALLATION and STARTUP
    • 2.1 Unpacking and Inspection
    • 2.2 Rack Mounting the turboIP-G2
      • 2.2.1 Rack Mounting – Full-Width turboIP-G2 Configuration
      • 2.2.2 1/2-Width turboIP-G2 – Rack Mounting Configurations using Kit PP-0000049
        • 2.2.2.1 1/2-Width turboIP-G2 – Single Unit Rack Mount Configuration
        • 2.2.2.2 1/2-Width turboIP-G2 – Dual Rack Mount Configuration
    • 2.3 turboIP-G2 Cabling and Startup
  • Chapter 3. REAR PANEL CONNECTORS
    • 3.1 Connectors Overview
    • 3.2 Console Connector (DB-9F)
    • 10/100/1000 BaseT Ethernet LAN / WAN Ports (2X RJ-45)
    • 3.4 10/100/1000 BaseT Ethernet MGT Port (1X RJ-45)
    • 3.5 IEC Line Input (AC Power) Connector
  • Chapter 4. CONFIGURATION and UPDATING
    • 4.1 Important Configuration Notes
    • 4.2 Required Equipment
    • 4.3 User Interfaces
      • 4.3.1 CONSOLE Settings
    • 4.4 End User License Agreement (EULA)
      • 4.4.1 End User License Agreement (EULA) Copy Protection
    • 4.5 turboIP-G2 Configuration Wizard
      • 4.5.1 Configuration Wizard – Operational Overview
        • 4.5.1.1 User Accounts / Username
        • 4.5.1.2 Password
        • 4.5.1.3 UTC (Coordinated Universal Time) Settings
        • 4.5.1.4 DOD Warning Banner
    • 4.6 Updating turboIP-G2 Software
      • 4.6.1 Preparing for the Software Update
        • 4.6.1.1 Verifying Communications between the User PC and CLI
        • 4.6.1.2 Identifying the Software Version and Management IP Address
          • 4.6.1.2.1 Identification Using the CLI
          • 4.6.1.2.2 Identification Using the Web Server Graphical User Interface (GUI)
        • 4.6.1.3 Creating and Renaming a Temporary Folder (for the Software Archive Download) on the User PC.
        • 4.6.1.4 Downloading the Archived Software Update File
      • 4.6.2 Updating Software
        • 4.6.2.1 Updating via the Command Line Interface (CLI)
        • 4.6.2.2 Updating via the Web Server Graphical User Interface (GUI)
          • 4.6.2.2.1 FTP UPDATE via the Web Server GUI
          • 4.6.2.2.2 UPLOAD UPDATE via the Web Server GUI
          • 4.6.2.2.3 Troubleshooting the Software Update Process
  • Chapter 5. MANAGEMENT via the CLI or WEB SERVER GUI
    • 5.1 Important Interface Operation Notes
    • 5.2 Command Line Interface (CLI)
      • 5.2.1 CLI Login
      • 5.2.2 CLI Operation using the SSH (Secure Shell) Interface
        • 5.2.2.1 Common Operational Features
      • 5.2.3 CLI Main Menu Screen
        • 5.2.3.1 Configure Interfaces Screen
          • 5.2.3.1.1 Configure Interfaces | Management IP Address Configuration Screen
          • 5.2.3.1.2 Configure Interfaces | Link Setting Configuration Screen
          • 5.2.3.1.3 Configure Interfaces | Advanced Options Screen
        • 5.2.3.2 Gateway Configuration Screen
          • 5.2.3.2.1 WAN Transmission Rate
          • 5.2.3.2.2 Maximum Transfer Unit (MTU)
          • 5.2.3.2.3 Congestion Control
        • 5.2.3.3 Routing Screen
          • 5.2.3.3.1 Routing | IPv4 Routing Table Screen
          • 5.2.3.3.2 Routing | IPv6 Routing Table Screen
        • 5.2.3.4 SNMP Screen
          • 5.2.3.4.1 SNMP Configuration Wizard
          • 5.2.3.4.2 SNMP Screen (SNMP v2)
          • 5.2.3.4.3 SNMP Screen (SNMP v3)
        • 5.2.3.5 Optimization Screen
        • 5.2.3.6 Selective Acceleration Screen
          • 5.2.3.6.1 Selective Acceleration | View/Edit Rules Screen
            • 5.2.3.6.1.1 Selective Acceleration | View/Edit Rules | Edit Rule Screen
          • 5.2.3.6.2 Selective Acceleration | Statistics Screen
        • 5.2.3.7 Administrative Functions Screen
          • 5.2.3.7.1 Administrative Functions | Configurations/Actions Screen
          • 5.2.3.7.2 Administrative Functions | Event Log Configuration Screen
            • 5.2.3.7.2.1 Administrative Functions | Event Log Configuration |View Log Screen
          • 5.2.3.7.3 Administrative Functions | Statistics Screen
            • 5.2.3.7.3.1 Administrative Functions | Save/Restore State Screen
        • 5.2.3.8 Command Line Interface Screen
          • 5.2.3.8.1 Interface Overview
          • 5.2.3.8.2 ‘get’ Query
          • 5.2.3.8.3 ‘ip’ Command
          • 5.2.3.8.4 ‘log’ Command
          • 5.2.3.8.5 ‘ping’ Command
          • 5.2.3.8.6 ‘route’ Command
          • 5.2.3.8.7 ‘route6’ Command
          • 5.2.3.8.8 ‘rule’ Command
          • 5.2.3.8.9 ‘set’ Command
          • 5.2.3.8.10 ‘snmp’ Command
          • 5.2.3.8.11 ‘stats’ Command
          • 5.2.3.8.12 ‘system’ Command
          • 5.2.3.8.13 ‘tcpdump’ Command
          • 5.2.3.8.14 ‘traceroute’ Command
          • 5.2.3.8.15 ‘user’ Command
    • 5.3 Web Server (HTTP) Graphical User Interface (GUI)
      • 5.3.1 Web Server GUI Login
      • 5.3.2 Web Server GUI Pages
        • 5.3.2.1 Acceleration Pages
          • 5.3.2.1.1 Acceleration | Skipware Page
          • 5.3.2.1.2 Acceleration | Optimization Page
        • 5.3.2.2 Interface Pages
          • Interface | Configuration Page
          • 5.3.2.2.2 Interface | Routes Page
          • 5.3.2.2.3 Interface | IPv6 Routes Page
          • 5.3.2.2.4 Interface | Advanced Page
        • 5.3.2.3 Graphs Page
        • 5.3.2.4 Selective Acceleration Pages
          • 5.3.2.4.1 Selective Acceleration | Rules Page
          • 5.3.2.4.2 Selective Acceleration | Stats Page
        • 5.3.2.5 Admin Pages
          • 5.3.2.5.1 Admin | Configuration Page
          • 5.3.2.5.2 Admin | Event Log Page
          • 5.3.2.5.3 Admin | Stats Page
  • Chapter 6. MANAGEMENT via SNMP
    • 6.1 Overview
    • 6.2 MIBII Support
    • 6.3 Private MIB Support
      • 6.3.1 MIB Tree
      • 6.3.2 turboIP-G2 Gateway Configuration
      • 6.3.3 turboIP-G2 Interface
      • 6.3.4 turboIP-G2 Route
      • 6.3.5 turboIP-G2 Selective Acceleration
      • 6.3.6 turboIP-G2 QoS Statistics Table
      • 6.3.7 turboIP-G2 Admin
      • 6.3.8 turboIP-G2 Admin Info
      • 6.3.9 turboIP-G2 Event Log
      • 6.3.10 turboIP-G2 Statistics
      • 6.3.11 turboIP-G2 Fail To Wire
      • 6.3.12 turboIP-G2 HTTP
      • 6.3.13 turboIP-G2 Optimization Configuration
      • 6.3.14 turboIP-G2 Notifications
      • 6.3.15 turboIP-G2 Process Notifications
  • Chapter 7. easyConnect™
    • 7.1 Introduction
    • 7.2 easyConnect™ ON
  • Chapter 8. FAIL TO WIRE
    • 8.1 Introduction
    • 8.2 Fail to Wire Board Operation
    • 8.3 Fail to Wire Board Installed
  • Appendix A. SAMPLE CONFIGURATIONS
    • A.1 Overview
    • A.2 Point-to-Point Configuration
    • A.3 Point-to-MultiPoint Configuration
    • A.4 Hub-Spoke Configuration
    • Dynamic Bandwidth Configuration
  • METRIC CONVERSIONS
• BACK COVER