Document Outline

• EG 33 Direct Vent
• OWNERS MANUAL
  • SAFETY PRECAUTIONS
• FOR SAFE INSTALLATION AND OPERATION OF YOUR “ENVI
  • • • TABLE OF CONTENTS
      • CODE APPROVALS
        • • PREPARATION FOR INSTALLATION
      • DECIDING WHERE TO LOCATE YOUR STOVE
      • DIMENSIONS:
        • Maintain sufficient clearances
• MOBILE HOME
  • • • • • INSTALLATION:
• NOTE:
  • • • • • Place the unit into the framed opening. Nail or screw the unit to the framing using the nailing flanges provided. MAKE SURE THAT THE UNIT IS LEVEL AND PLUMB BEFORE NAILING OR SCREWING TO THE FRAMING MEMBERS. ALSO INSURE THAT THE BOTTOM OF THE UNIT IS LEV
          • Once the unit has been secured, install all venting according to local codes and guidelines and restrictions applied in this manual.
          • REQUIRED MANTLE CLEARANCES
          • VENT RESTRICTIONS:
          • FLUE COLLAR INSTALLATION
          • VENT TERMINAL CLEARANCES
            • ** Only permitted if verandah. Porch, deck, or balcony is fully open on a minimum of 2 sides beneath the floor
            • If extra elbows are being used, overall allowable length will be reduced by 3 ft. per additional elbow
              • • Simpson Duravent Parts
              • NumberDescription
              • 908B6” Pipe Length, Black
          • PLANNING YOUR INSTALLATION
  • HORIZONTAL INSTALLATION
• Place a bead of Mil-Pac on the outer edge of the inner exhaust pipe (non-flared end). Place a bead of high temperature silicone on the male edge of the outer pipe. Push the pipe sections completely together, then twist-lock one section clockwise approx
  • • • • • • • • NOTE:
          • VERTICAL INSTALLATION
            • • • NOTES:
                • NOTES:
          • INSTALLATION OF LOGSET and EMBERS
            • INSTALLING THE GLOWING EMBERS and LOGSET
              • REMOVING AND INSTALLING THE BRICK PANELS
          • OPERATING INSTRUCTIONS
            • NOTE: Check to be sure the pilot flame engulfs the thermocouple and that the burners light completely.
            • 
          • ROUTINE MAINTENANCE and TECHNICAL
            • • • OPENING THE DOOR
                • CLEANING THE GLASS
              • DO NOT CLEAN GLASS WHEN HOT
                • TO REPLACE DOOR GLASS
            • TO REPLACE:
            • Glass must be purchased from an Envirogas dealer.
            • No substitute materials are allowed.
              • • CLEANING THE INSIDE OF THE FIREBOX
                • REMOVING BURNER CONTROLS:
                • CAUTION:
                • ADJUSTING VENTURI AIR SETTINGS
          • To adjust for high altitude: open the lower louvers, Locate the venturis between the burner and control trays. Loosen the 2 set screws with a long screwdriver and rotate the air shutters to the correct setting.
          • TROUBLE SHOOTING
          • GAS LINE CONNECTION
            • • GAS LINE CONNECTION
            • Always check for gas leaks with a soap and water solution after completing the required pressure test.
              • TO TEST VALVE PRESSURES
      • ELECTRICAL
        • • INSTALLING OR REMOVING THE BLOWER
            • The blower does not require lubrication.
          • FUEL CONVERSION
          • WARRANTY
            • To the Dealer
            • To the Distributor
          • INSTALLATION DATA SHEET
            • • • Model: EG 33 Zero Clearance Direct Vent