Document Outline

• Precautions
• Warranty
• FCC Class A Notice
• Table of Contents
• Chapter 1 • Introduction
  • About this Manual
  • About the Matrix Switchers
• Chapter 2 • Installation
  • Rear Panel Installation Features
  • Front Panel Configuration Port
• Chapter 3 • Front Panel Operation
  • Creating a Tie
  • Saving or Recalling a Preset
  • Setting the Front Panel Locks (Executive Modes)
    • Selecting Lock mode 2 or toggling between mode 2 and mode 0
    • Selecting Lock mode 2 or toggling between mode 2 and mode 1
    • Viewing and Adjusting the Input Audio Level and Output Volume
  • Viewing Ties (and Muting Outputs)
• Chapter 4 • Remote Control
  • Selected SIS Commands
  • Installing and Starting the Control Program
    • Installing the program
    • Starting the program
  • Button-Label Generator Program
• Part numbers and contact info
• xxx.pdf
  • Chapter One
  • Introduction
    • About this Manual
    • About the Matrix Switchers
  • Chapter Two
  • Installation
    • Rear Panel Installation Features
    • Front Panel Configuration Port
  • Chapter Three
  • Front Panel Operation
    • Creating a Tie
    • Saving or Recalling a Preset
    • Setting the Front Panel Locks (Executive Modes)
      • Selecting Lock mode 2 or toggling between mode 2 and mode 0
      • Selecting Lock mode 2 or toggling between mode 2 and mode 1
      • Viewing and Adjusting the Input Audio Level and Output Volume
    • Viewing Ties (and Muting Outputs)
  • Chapter Four
  • Remote Control
    • Selected SIS Commands
    • Installing and Starting the Control Program
      • Installing the program
      • Starting the program
    • Button-Label Generator Program
• xxx.pdf
  • Chapter One
  • Introduction
    • About this Manual
    • About the Matrix Switchers
  • Chapter Two
  • Installation
    • Rear Panel Installation Features
    • Front Panel Configuration Port
  • Chapter Three
  • Front Panel Operation
    • Creating a Tie
    • Saving or Recalling a Preset
    • Setting the Front Panel Locks (Executive Modes)
      • Selecting Lock mode 2 or toggling between mode 2 and mode 0
      • Selecting Lock mode 2 or toggling between mode 2 and mode 1
      • Viewing and Adjusting the Input Audio Level and Output Volume
    • Viewing Ties (and Muting Outputs)
  • Chapter Four
  • Remote Control
    • Selected SIS Commands
    • Installing and Starting the Control Program
      • Installing the program
      • Starting the program
    • Button-Label Generator Program