Document Outline

• Chapter 1 Introduction and Quick Start
  • Introduction
  • VMSE Firmware Options
  • SRTP/SNP Firmware
  • Pass Thru Firmware
  • Modbus TCP/ RTU firmware
  • Quick Start
  • Configuration
• Chapter 2 VMSE Interfaces
  • Serial Interface
  • Network Interface
  • Hardware Address (MAC Address)
  • Power Requirements
• Chapter 3 Network Protocols
  • Packing Algorithm (PassThru Firmware only)
  • IP Address
  • Port Number
• Chapter 4 Configuration
  • Configuration Steps
  • Entering Serial Configuration Mode
  • Entering Network Configuration Mode_
  • VMSE’s IP Address
    • Default IP Address
    • Assigning a New IP Address
    • Unix
  • Configuration Parameters
  • SRTP/SNP Firmware – Configuration Setup
  • Network/IP Settings
  • IP Address
  • Gateway IP Address
  • Netmask
  • Channel, Serial, and Protocol Setups
  • SRTP/SNP Protocol Mode
  • Serial Interface Configuration
  • SNP T1 – T4 Timers
  • SNP ID to IP Address Mapping ( only for SRTP/SNP Mode# 2)
  • PassThru Firmware Configuration Setup
  • Basic Parameters
    • IP Address
    • Gateway IP Address
    • Netmask
    • Telnet Configuration Password
    • Channel 1 Parameters
    • Baud Rate
    • Interface Mode
    • Flow Control
    • Port Number
    • Remote IP Address
    • Remote TCP Port
    • Connect Mode
    • Automatic Connection Address
    • Datagram Mode
    • Modem Emulation Mode
    • Disconnect Mode
    • Force Telnet Mode
    • Buffer Flushing
    • Inactivity Timeout
    • Pack Control
    • Send Characters
    • Telnet Terminal Type
  • Modbus TCP/RTU Firmware Configuration Setup
  • Network/IP Settings
    • IP Address
    • Gateway IP Address
    • Netmask
  • Serial and Mode Settings
    • Protocol
    • Serial Interface
  • Modem Control Settings
  • Advanced Modbus Protocol Settings
  • Modbus ID to IP Address Mapping ( only used for Master)
• Chapter 5 Monitor Mode and Firmware Upgrade
  • Monitor Commands
  • Command result codes:
  • Firmware Download Using Serial Port
  • Firmware Distribution
  • Firmware Download Using a Network Host
  • Windows NT Procedure
    • Windows NT Command Line Example Code Explanation
    • VMSE Firmware File List:
    • Destination (Password)
  • Windows 95/98 Procedure
    • Obtaining TFTP Software for Windows 95/98
• Chapter 6 Serial Line Interfaces
  • Serial Line Interfaces
  • RJ45 Connector Pin-outs (RS-232)
    • Screw Block Connector Pin-outs and Other Components
    • Cable Diagrams
• Chapter 7 Technical Data
  • CPU, Memory, and Controllers
  • Serial Interface
  • Network Interface
  • Power Supply (not included)
  • Power Consumption
  • Operating Temperature
  • LEDs
  • Case
  • Dimensions
  • Weight
• Appendix A IP Addresses
  • IP Addressing
  • Class A Network
  • Class B Network
  • Class C Network
  • Network Address
  • Broadcast Address
  • IP Netmask
  • Network RFC’s
• Appendix B Binary to HExadecimal Conversion Table
• Appendix C Declaration of Conformity
• Index