Document Outline

• MAINTENANCE INSTRUCTIONS
• + WORKSHOP MANUALforWS - Single Pressure Pump
• RECOMMENDED SPARES
  • • • • • • • REAR WEAR RING
    • INSTALLATION
      • MAINTENANCE
• It is the responsibility of the user to ensure that the equipment is maintained in a safe operational condition, as per regulation 5 in the Provision and Use of Work Equipment Regulations 1998.
  • • • PUMP DRIVE AND PRIMING SYSTEMS
      • NOISE
      • THERMAL RELIEF VALVE
      • OPERATION
        • Engineering Director
      • LUBRICATION
    • PROTECTION AGAINST FROST
      • • • • Section 1
              • To Remove
            • Section 2
              • • WEARING RING MAINTENANCE
              • To Refit
                • SECTION 3
                • LOW PRESSURE IMPELLER AND REAR WEAR RING
              • To Remove
              • Maintenance
          • Fig 3-1Checking the wearing diameters of the low pressure impeller
            • • To Refit
              • Rear Wear Ring
      • Pump Type
        • • • • To Refit
• Re-assembly of the seal is completed as described below. Please note: Mechanical Seals are precision-engineered devices and extreme care must be taken to ensure that no damage occurs to the lapped faces.
  • • • • • • Section 5
• LOW PRESSURE MANIFOLD AND FILTER HOUSING
  • • • • • • • To Remove
              • Reassembly
              • Filter Housing
            • Section 7
              • To Remove End Covers
              • Reassembly
• Supplement for World Series Pump Maintenance – WT
  • • • • • • • To Remove
              • To Refit
            • Section 8
    • PUMP BODY
      • • • • • To Remove
              • To Refit
            • Section 9
    • FRONT END OIL SEAL AND WEAR RING
      • • • • • Refitting
            • Section 10
    • REAR END OIL SEAL AND WEAR RING
      • • • • • Refitting
            • Section 11
    • BEARING HOUSING
      • • • • • To Remove
              • To Rebuild
• SMR-ACManual, 029-0020-78-0 - Rev-B.pdf
  • SMR-AC Addendun "A", 029-0020-78-0, Rev-B
    • NOTICE !
    • Contents
    • Addendum: SMR-AC Installation
      • A.1 Unpacking
        • Lifting the System
          • Figure A-1: Lifting the SMR-AC System (Three-Point Lift)
      • A.2 SMR-AC System Mounting
        • SMR-AC CAFSPro Main Pump System Assembly
          • Figure A-2: Shock Mounting
        • Oil Separator Tank Assembly
          • Figure A-3: Separator Tank Mounting Bracket
          • Figure A-4: Lifting Separator Tank
        • Panel Strainer, Water Cooling
      • A.3 Plumbing Connections
      • A.4 Oil Separator Tank
        • Figure A-6: Separator Tank Installation Overview
        • Figure A-7: Depressurizing Valve Assembly
      • A.5 Air Filter
        • Figure A-8: Typical Air Filter Installation
      • A.6 Electrical Connections
        • Harness Connections
          • Table A-9: Harness Connections
      • A.7 Fluid Levels
  • Return HOME Page
  • EXIT