Impex WM-354 Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for WM-354 Impex
Manuals
| Recognized languages: | English |
|---|---|
| Pages: | 12 |
| Size: | 1.89 MB |
Show table of contents
Read manual
Document Outline
- BEFORE YOU BEGIN...................................................................................…. 1
- IMPORTANT SAFETY NOTICES..................................................................…. 2
- HARDWARE IDENTIFIER.....…....................................................................…. 3
- ASSEMBLY INSTRUCTIONS........................................................................…. 4
- EXPLODED DIAGRAM………………………………………………………………. 9
- PARTS LIST...............................................................................................……. 10
- WARRANTY.................................................................................................…. 11
- ORDERING PARTS.......................................................................................… 11
- ASSEMBLY INSTRUCTION
- Attach one (3/4” Washer (#31) onto a M10 x 6” Hex Bolt (#35). Insert the Bolt through the Butterfly (#9). Secure the Bolt with one M10 x 5/8” Regular Nut (#36)
- Insert the Bolt through the Rear Upright Beam (#1). Secure it with a Ø ¾” Washer (#31) and M10 Aircraft Nut (#32). DO NOT over tighten the Bolt. Make sure the Butterfly is able to swivel on the Upright Beam.
- Insert a Butterfly Foam Tube (#10) through the hole on the Butterfly. Push a Foam Roll (#20) onto the Tube. Place a Spring Clip (#23) onto the weight post on the Butterfly.
- Repeat above procedures A, B and C to install the other side.
- Attach the Leg Developer (#11) to the Front Leg (#8). Secure it with one M8 x 3 1/8” Hex Bolt (#27), two Ø 5/8” Washers (#28), and one M8 Aircraft Nut (#29).
- Insert two Foam Tubes (#12) halfway through the holes on the Leg Developer. Push four Foam Rolls (#20) onto the Tubes from both sides.
- Place a Spring Clip (#23) onto the weight post on the Leg Developer.
- Attach the hole-side of the Backrest Supports (#14) onto both ends of the pivot on the Main Seat Support (#6). Place the other end rest against the Backrest Adjustment Bar (#4).
- Place the Backrest Board (#15) onto the Backrest Supports. Secure it with four M6 x 1 3/8” Hex Bolts (#37) and Ø ½” Washers (#38).
- Place the Seat Pad (#16) onto the Main Seat Support. Secure it with four M6 x 1 3/8” Hex Bolts (#37) and Ø ½” Washers (#38).
- Attach the Arm Curl Pad (#17) to the Arm Curl Stand (#13). Secure it with two M8 x 5/8” Hex Bolts (#33) and Ø 5/8” Washers (#28).
- Insert the Arm Curl Stand into the top opening on the Front Leg. Secure it with a Lock Knob (#25).
- 20 Foam Roll 6