Document Outline

• Contents
• Using This Guide
  • Purpose and Audience
  • Chapter Summary
  • Additional Documentation
• Introduction
  • Capabilities
  • Applications
  • Protocol
  • Addresses and Port Numbers
    • Hardware Address
    • IP Address
    • Port Numbers
  • Logon Methods
• Getting Started
  • Required Information
    • Hardware Address
    • IP Address
  • Using DeviceInstaller to Assign an IP Address
    • Installing DeviceInstaller
    • Assigning an IP Address
  • Using Web-Manager to Configure the Unit
  • Unit Configuration Settings
  • Server Properties
  • Port Properties
    • Serial Port Settings
    • Connect Mode Settings
    • Dedicated Connection
    • Flush Mode Input Buffer
    • Packing Algorithm
    • Additional Settings
  • Factory Settings
  • Update Settings
• Using Setup Mode for Configuration
  • Accessing Setup Mode
    • Using a Telnet Connection
    • Using the Serial Port
  • Server Configuration (Network Configuration)
    • IP Address
    • Set Gateway IP Address
    • Netmask: Number of Bits for Host Part
    • Change Telnet Configuration Password
    • DHCP Name
  • Channel 1 Configuration (Serial Port Parameters)
    • Baudrate
    • I/F (Interface) Mode
    • Flow
    • Port Number
    • Connect Mode
    • Remote IP Address
    • Remote Port
    • DisConnMode
    • Flush Mode (Buffer Flushing)
    • Pack Control
    • DisConnTime (Inactivity Timeout)
    • Send Characters
    • Telnet Terminal Type
    • Channel (Port) Password
  • E-mail Settings
    • E-mail Setup
    • Trigger Setup
  • Expert Settings
    • TCP Keepalive time in seconds
    • ARP Cache timeout in seconds
  • Security Settings
    • Disable SNMP
    • SNMP Community Name
    • Disable Telnet Setup
    • Disable TFTP Firmware Upgrade
    • Disable Port 77FE (Hex)
    • Disable Web Server
    • Disable ECHO Ports
    • Enable Encryption
    • Enable Enhanced Password
    • Disable Port 77F0 (Hex)
  • Factory Defaults
    • Channel 1 Configuration
    • Expert Settings
    • Security Settings
    • E-mail Settings
  • Exit Configuration Mode
• GPIO Interface
  • Configurable Pins
    • Features:
  • Control Protocol
    • Guidelines
    • Commands
  • Examples
• Updating Firmware
  • Obtaining Firmware
  • Reloading Firmware
    • Using TFTP
    • Recovering the Firmware using the Serial Port
• Monitoring the Network
  • Entering Monitor Mode via the Serial Port
    • Entering Monitor Mode via the Network Port
    • Monitor Mode Commands
• Troubleshooting
  • Problems and Error Messages
  • Technical Support
• IP Addresses
  • Components of the IP Address
    • Network Portion
    • Subnet Portion
    • Host Portion
  • Network Address
  • Broadcast Address
  • IP Subnet Mask
  • Private IP Networks and the Internet
  • Network RFCs
  • Alternative Ways to Assign an IP Address
    • DHCP
    • AutoIP
    • ARP and Telnet
• Binary to Hex Conversions
  • Connect Mode Options
  • Disconnect Mode Options
  • Flush Mode (Buffer Flushing) Options
  • Interface Mode Options
  • Pack Control Options
• Networking Terms