Document Outline

• Technical Support
  • How to Get Technical Support
  • Before You Contact MTS
  • If You Contact MTS by Phone
  • Problem Submittal Form in MTS Manuals
• Preface
  • Before You Begin
  • Documentation Conventions
• Safety
  • General Safety Practices
  • Safety Practices Before Operating the System
  • Safety Practices While Operating the System
  • Load Unit Hazard Labels
• Introduction
  • Overview
    • What you need to know
  • EU Declarations
  • Component Description
  • Functional Description
  • Series 661 Force Transducer
    • Dimensions
  • Specifications
• Installation
  • About Installation
  • Unpacking Horizontal Configuration
    • Prerequisites
    • Unpack the Load Unit (Horizontal Configuration)
  • Lifting and Moving the Load Unit
    • Overview
    • Lift and Move the Load Unit
  • Connecting Cables
    • Prerequisite
    • Cable Connections
    • Low Flow Power Supply
  • Connect Hydraulics
  • Unlock the Crosshead
  • Anchoring the Load Unit
• Operation
  • Special Transducer Considerations
  • Control Module
  • 370 Load Unit: Crush Point Hazards
  • Specimen Installation
    • Install the Specimen
  • Position the Crosshead Hydraulically
  • Position the Crosshead Manually
    • Manually Clamp the Crosshead
    • Crosshead Clamping Bolt Torque Values
  • Adjust the Grip Clamp Rate
  • Adjust the Grip Clamp Force
  • Handset Control
    • Handset Control Functions
  • Standard Test Area Enclosure Operation
    • Hydraulic Power Off
    • Specimen Installation and Setup
      • Specimen Installation and Setup–Interrupt Operation
      • Specimen Installation and Setup–Resume Operation
    • Run Mode
    • Service
    • Emergency Stop and Actuator Velocity Limiting Switch
    • Interlock logic
• Maintenance
  • Routine Maintenance Overview Checklist
  • Other Maintenance Tasks
  • Daily Inspections
  • Clean the Columns
  • Prevent Rust
  • Maintain Airmount Pressures
  • Label Inspection
  • Adjust the Hydraulic Locks
  • Lubricate the Crosshead Locking Bolts
  • Aligning the Force Transducer
    • Required Equipment
    • Align the Force Transducer
  • Series 111 Accumulator: Maintenance Overview
  • Series 111 Accumulator: Check and Change Precharge Pressure
    • Equipment
    • Prerequisites
    • Check the Precharge Pressure
    • Change the Precharge Pressure
      • Decrease Pressure
      • Increase Pressure
  • Actuator
  • Change the HSM Filter
    • Change the HSM Filter
  • 252 Servovalve
    • Replacing the Servovalve Filter Element
    • Replace the Servovalve Filter Element
    • Adjusting the Mechanical Null
    • Adjust the Mechanical Null
  • Performing Sensor Calibration
• Decommissioning
  • Decommission the System
• Declarations
  • Declaration of Conformity
  • Declaration of Incorporation