Document Outline

• Title Page
• Table of Contents
• SAFETY CONSIDERATIONS
• REGULATORY INFORMATION
  • 1. Regulatory Requirements
  • 2. FCC Part 15 Requirements ix
  • 3. FCC Part 68 Registration ix
    • 3.1 Company Notification
    • 3.2 Service Requirements
    • 3.3 Location of FCC Compliance Labels
  • 4. Direct-Inward Dialing (DID) Calls
  • 5. Regulatory Information on Single-Line Analog Telephones xi
  • 6. Hearing Aid Compatibility xi
  • 7. Industry Canada CS-03 xi
  • 8. Safety Certifications xii
    • 8.1 Safety Considerations
• CHAPTER 1 INTRODUCTION
  • 1. Purpose
  • 2. Reference Manual
  • 3. How To Follow This Manual
    • 3.1 Scope Of Installation Procedures
• CHAPTER 2 GENERAL INFORMATION
  • 1. TRUNKING DIAGRAM
  • 2. SYSTEM CONFIGURATIONS
• CHAPTER 3 INSTALLATION PROCEDURES
  • 1. Precautions
    • 1.1 Grounding Requirements
      • 1.1.1 Equipment Ground
      • 1.1.2 Supplementary Ground
    • 1.2 Static Electricity Precautions
    • 1.3 Procedure for Unplugging/Plugging Circuit Cards
  • 2. Procedure
  • NAP 200-001 Unpacking
    • 1. Unpacking Procedure
  • NAP 200-002 Marking and Drilling
    • 1. Confirmation of the Equipment Layout
    • 2. Marking
      • 2.1 Floor Standing
      • 2.2 Wall Mounting
    • 3. Drilling
  • NAP 200-003 Installation of Main Equipment
    • 1. Floor Standing Installation
    • 2. Wall Mounting Installation
    • 3. 19-Inch Rack-Mounting Installation
      • 3.1. Single-PIM Installation
      • 3.2. Multiple-PIM Installation
    • 4. Desk Top Installation
  • NAP 200-004 Installation of Peripheral Equipment
    • 1. Installation of External MDF
    • 2. Installation of SN610 ATTCON
    • 3. Installation of SN716 DESKCON
  • NAP 200-005 Connection of Battery
    • 1. Battery Connection
      • 1.1. Internal Battery Connection
      • 1.2. Battery Connection in the BATTM
  • NAP 200-006 Cable Running to the MDF
    • 1. MDF Cable
    • 2. Cable Running to the External MDF
    • 3. Cable Running to the MDFM
  • NAP 200-007 Termination of Cables on the MDF
    • 1. Cable Connection to the MDF
    • 2. MDF Cross Connections
  • NAP 200-008 Mounting of Circuit Cards
  • NAP 200-009 Installation of Back up MP System
    • 1. Mounting of MP Cards
    • 2. Cable Connection between MP Cards
    • 3. Starting Up the Back up MP System
    • 4. Operation Test
    • 5. MP Changeover Test
  • NAP 200-010 System Initialization and System Data Entry
    • 1. System Initialization
      • 1.1 All Clear, Except LEN0000 CAT
      • 1.2 Resident System Program
    • 4. System Data Entry
      • 1.3 CAT
      • 1.4 MAT
  • NAP 200-011 Operation Test
  • NAP 200-012 Cleaning and Visual Check
    • 1. Cleaning
    • 2. Visual Check
  • NAP 200-013 Mounting of the Front Cover