Document Outline

• 1 Introduction
  • Printer Overview
    • Printronix N7000 and N7000 H-Series Cartridge Ribbon Printers (CRP) Series
  • Consumable Monitoring with PrintNet Enterprise
  • Graphics Enhancements
  • Taking Care of Your Printer
  • Conventions in this Manual
  • Warnings and Special Information
  • Related Documents
  • Contact Information
    • Printronix Customer Support Center
    • Printronix Supplies Department
    • Corporate Offices
• 2 Setting Up The Printer
  • Before You Begin
  • Power Requirements
  • Select a Site
  • Printer Dimensions
  • Printer Component Locations
• 3 Operating The Printer
  • Powering on the Printer
  • Operating Modes
  • The Control Panel
    • Control Panel Keys
    • Cancel a Print Job
  • Operational Procedures
    • Reload Paper
    • Unload Paper
  • Integrated Print Management System
    • Output Darkness
    • Loading a Used Ribbon Cartridge
    • Lighter or Darker Print
    • Changing Ribbon Cartridge
• 4 The Configuration Menus
  • Configuration Overview
    • Changing Parameter Settings
    • Saving Parameter Settings
    • Default and Custom Configurations
    • Navigating the Menus
    • Changing Parameters Example
    • Auto Save Configuration
    • Saving Your New Configuration
    • Optimizing Print Quality (N7000 STD Only)
    • Optimizing Print Speed (N7000 STD Only)
  • Main Menu
    • N7000 STD Firmware
    • N7000 H-Series Firmware
    • QUICK SETUP Menu Definitions
  • CONFIG. CONTROL
  • HOST INTERFACE
    • Auto Switching Submenu
    • Centronics (Parallel) Submenu
    • Dataproducts Submenu
    • Serial Submenu
    • IEEE 1284 Parallel (Bidirectional) Submenu
  • NETWORK SETUP Menu
    • ETHERNET ADDRESS
    • ETHERNET PARAMS
  • ACTIVE IGP EMUL - (N7000 STD)
  • EMULATION
  • LinePrinter+ Emulation (N7000 STD)
    • P-Series Emulation
    • P-Series XQ Emulation
    • Serial Matrix Emulation
    • Proprinter XL Emulation
    • Epson FX Emulation
  • LinePrinter + Emulation (N7000 H-Series)
    • LQ-1600K Menu
    • OKI Menu
  • IGP/PGL Emulation
    • Features
    • Configuring The Emulation With The Control Panel
    • IGP/PGL Submenu
  • IGP/VGL Emulation
    • Features
    • Configuring the Emulation with the Control Panel
    • IGP/VGL Submenu
  • PRINTER CONTROL
  • ADVANCED USER
  • DIAGNOSTICS
  • PRINTER MGMT
• 5 Interfaces
  • Overview
  • Dataproducts Parallel Interface
    • Dataproducts Parallel Interface Signals
  • Centronics Parallel Interface
    • Centronics Parallel Interface Signals
  • IEEE 1284 Parallel Interface
    • Compatibility Mode
    • Nibble Mode
    • Byte Mode
    • Signals
    • Terminating Resistor Configurations
  • RS-232 and RS-422 Serial Interfaces
    • RS-232
    • RS-422
• 6 Reprogramming the Security Key
  • Reprogramming the Security Key
    • How to Program the Security Key
• 7 Troubleshooting
  • Cleaning Requirements
    • Exterior Cleaning
    • Interior Cleaning
  • Diagnosing Problems
    • Bar Code Verification
    • Printing a Hex Dump
    • Fault Messages
    • N7000 STD ASCII Printers Fault Messages
    • N7000 H-Series Printers Fault Messages
• A Printer Specifications
  • Ribbon Cartridge Specifications
  • Paper Specifications
  • Labels
  • Printer Weight and Dimensions
  • Environmental Characteristics
  • Acoustic Noise Level
  • Energy Star
  • Electrical Characteristics
  • Interfaces
  • Printing Rates
• B ASCII Character Set
• C Zero Tear Pedestal Printer
  • Overview
  • Operation
    • Position the Paper Input and Adjust the Paper Guides
    • Load Paper
    • Position the Paper Out Sensor
    • Set the Tear Bar Distance
    • Set the Top of Form
  • ZTP SETTINGS Menu
  • Performance Limitations
• D Customer Support
  • Printronix Customer Support Center
  • Printronix Supplies Department
  • Corporate Offices
• E Communication Notices
  • Notices
  • Energy Star
  • Communication Statements
  • Software License Agreement