Document Outline

• Preface
  • Important information
    • Safety notices
    • EMC conformance
    • Handbook information
  • Introduction
  • Data inputs
    • SeaTalk
      • Using with SeaTalk Autopilot
    • Stand alone operation
  • Options
    • Linear transducer
    • Mounting
  • Parts supplied
• Chapter 1: Operation
  • 1.1 Getting started
    • Displayed information
    • Operation with other instruments
  • 1.2 Normal use
    • Display illumination
  • 1.3 Remote control
• Chapter 2: Maintenance & Troubleshooting
  • 2.1 Maintenance
    • Servicing and safety
    • Instrument
    • Transducer
    • Cabling
  • 2.2 Troubleshooting
    • Preliminary procedures
  • 2.3 Fault location
    • Technical support
      • World wide web
      • Telephone help line
      • Help us to help you
• Chapter 3: Installation
  • 3.1 Planning your installation
    • Site requirements
      • Transducer
      • Instrument
    • EMC installation guidelines
      • Suppression ferrites
      • Connections to other equipment
  • 3.2 Procedures
    • Unpacking
    • Fitting the instrument
      • Surface mounting
      • Flush mounting
        • Fitting the low-profile bezel
        • Flush mounting procedure
      • Bracket mounting
    • Fitting transducers
      • Rotary Rudder Reference Transducer
        • Mounting
        • Connecting to the tiller
      • Linear Rudder Reference Transducer
        • Mounting
      • Transducer cabling
        • General
        • Running the cable
    • Connecting the instrument
      • Introduction
      • Signal connections
      • Power supply connections
        • SeaTalk systems
        • Stand alone instruments
• Chapter 4: Calibration
  • 4.1 Introduction
    • EMC conformance
  • 4.2 Rudder angle offset adjustment