Document Outline

• FM Stereo FM-AM Receiver
  • WARNING
    • IMPORTANT
    • CAUTION
    • Note to CATV system installer
    • Owner's record
  • Precautions
    • On safety
    • On power sources
    • On placement
    • On operation
    • On cleaning
  • About This Manual
    • Type of differences
    • Conventions
    • Getting Started
    • Additional Information
    • Index 20
    • Rear Panel Descriptions 21
    • Remote Button Descriptions 22
    • Quick Reference Guide 23
  • Unpacking
  • Hookup Overview
    • Inserting batteries into the remote
      • Notes
    • Before you get started
  • Antenna Hookups
    • Overview
    • Connecting a ground wire
  • Audio Component Hookups
    • FM wire antenna
    • AM loop antenna
    • Overview
      • 'Q' If you have poor FM reception
      • What cords will I need?
    • Hookups
      • Turntable
      • If your turntable has an earth lead
  • Speaker System.Hookups
    • Overview
      • what cords will I need?
    • Hookups
      • Front speakers Front speaker (R)
      • Rear and center speakers
      • Active woofer (STR-DE505 only)
      • 'Q' If your TV monitor uses separate speakers
    • Selecting the speaker system
  • Video Component Hookups
    • Overview
    • Hookups
      • VCR
  • AC Hookups
    • Connecting the AC power cord
  • Before You Use Your Receiver
  • Selecting a Component
    • Watching/listening to video programs
      • If the component does not turn on
      • To turn off the components
      • 'Q' If you use a Sony TV
    • Using the remote |
      • 'Q' When you watch TV without using the receiver (only for Sony TVs)
    • Operating one component while using another (Background Operation)
    • Changing the factory setting of a function button
      • To reset the setting to the factory setting
  • Receiving Broadcasts
    • Example 1: FM 102.50 MH
    • To receive other stations
    • '(j' If an FM stereo program is distorted
    • ■Q' If you cannot tune in a station and the entered numbers are flashing
    • y' To watch FM simulcast TV programs
    • y If you enter a frequency not covered by the tuning interval
    • Receiving broadcasts by scanning stations (automatic tuning)
      • 'Q' If the STEREO indicator remains off
  • Presetting Radio Stations
    • To change a preset station
    • Note
    • Tuning preset stations (preset tuning)
      • You can tune by scanning the preset stations
      • -C2-
  • Recording
    • Recording on an audio tape or MiniDisc
    • Recording on a video tape
      • 'Q' You can replace audio while editing a video tape
  • Choosing a Surround Mode
    • When you use the remote
    • 'y* You can find Dolby Surround-encoded software by looking at the packaging
    • Note
    • Adjusting the Effect Level (for THEATER and HALL only)
      • Note
      • To turn off surround sound
  • Getting the Most Out of Dolby Pro Logic Surround Sound
    • Selecting the center mode
    • Adjusting the speaker volume
    • Adjusting the delay time
      • Note
      • 'Q' You can adjust all speakers at one time
      • You can also adjust the volume level with the controls on the receiver
      • ‘Q* You can increase the-outputdevel of the rear speakers
  • Troubleshooting
    • There's no sound or only a very low-level sound is heard.
    • The left and right sounds are unbalanced or reversed.
    • Severe hum or noise is heard.
    • No sound is heard from the center speaker.
    • Radio stations cannot be tuned in.
    • Surround effect cannot be obtained.
    • No picture or an unclear picture is seen on the TV screen.
    • Recording cannot be made.
    • The remote does not function.
    • No sound or only a very low-level sound is heard from the rear speakers.
  • Specifications
    • Audio power specifications
    • Amplifier section
    • FM tuner section
    • AM tuner section
  • Glossary
    • A. B
    • E, F. G
    • H. I, J, K, L, M
    • N, O
  • u
    • V
    • w. X, Y, Z
    • Receiving Broadcasts Presetting Radio
    • Scanning Radio Receiving Preset
    • Using Pre-programmed Sound Fields