Document Outline

• Spectra 12000™ Library User Guide
  • Notices
  • License
  • Warranty
    • Firmware Support Process
  • Warnings and Cautions
    • Tapes
    • AC Power
  • 1 Introduction
    • Introduction
    • About the Gator Architecture
    • Option Enablement
    • A Tour of the Spectra 12000 Library
    • The Library Controller Stylus
    • A Tour of the Library Controller
      • IP Address and User
      • Exception Bar
      • Toolbars
      • General Toolbar
      • Configuration Toolbar
      • Maintenance Toolbar
      • Security Toolbar
    • Getting Started
  • 2 Installing the Spectra 12000 Library
    • Preparing a Controlled Environment
      • Media and Hardware Environment
      • Air Quality
    • Unpacking the Spectra 12000 Library
    • Connecting the SCSI Cables and Terminators
    • Connecting the Fibre Channel Cables
    • Connecting the Ethernet Cables
    • Turning the Library On and Off
  • 3 Using Security
    • Setting Up Security
      • To Set Up a User
      • To Delete a User
  • 4 Partitioning the Spectra 12000 Library
    • Displaying the Configuration Toolbar
    • Partitioning the Library
  • 5 Configuring the Spectra 12000 S-QIP
    • Displaying the Configuration Toolbar
    • Configuring S-QIPs
    • S-QIP Configure Controller Screen
      • S-QIP Default ID Settings
  • 6 Configuring the Spectra 12000 Library F-QIP
    • Displaying the Configuration Toolbar
    • Configuring F-QIPs
    • F-QIP Configure Controller Screen
    • About Serverless Backup
    • Configuring the F-QIP for Serverless Backup
      • Enabling Serverless Backup
      • Serverless Backup F-QIP Setup
  • 7 Configuring the Spectra 12000 E-QIP
    • About TAOS™
      • TAOS ITP
      • NDMP Enabled by TAOS
      • Sharing Tape Devices
    • TAOS User Interfaces
    • Connecting to the Serial Port
    • Setting Up the E-QIP
      • Password Configuration
      • Ethernet Configuration
    • Setting Up TAOS ITP
      • TAOS ITP Configuration
      • TAOS ITP Driver Installation
        • Installing TAOS ITP on Windows NT
        • Installing TAOS ITP on Windows 2000
        • Installing TAOS ITP on Solaris
        • Installing TAOS ITP on Linux
    • Setting Up NDMP Enabled by TAOS
      • Enabling TAOS NDMP
      • Configuring NDMP Enabled by TAOS
  • 8 Configuring the Drives
    • Configuring SCSI IDs, Emulation and Dip Switch Settings
  • 9 Using the Spectra 12000 Library
    • Checking Library Status
    • Checking Robotics
      • To Enable Keys
      • To Set IP Addresses
    • Checking Inventory
      • Inserting and Ejecting Cartridges
      • Insert New Media
      • Eject Media
    • Checking Drives
      • Checking Drive Status
    • The Maintenance Toolbar
    • Checking Diagnostics
    • Updating Firmware
      • Accessing Firmware from a Remote Server
      • Accessing Firmware from an Alternate Location
        • To Upgrade from Floppy Disks (Spectra Logic P.N. 90919021)
      • Reset Picker Parameters
    • Viewing the F-QIP Configuration
    • Checking Resources in Use
    • Deleting a Partition Configuration
  • 10 Using the Drive
    • Bar Code Labels
    • Using AIT Data Cartridges
      • Write-Protecting and Recording
      • Storing Cartridges Outside the Library
    • Caring for Data Cartridges
    • Cleaning the AIT Drive Heads
  • 11 Maintaining the Spectra 12000 Library
    • Changing the Spectra 12000 Library Air Filters
    • Adding Drives
    • Adding QIPs
    • Troubleshooting the Spectra 12000 Library
      • Troubleshooting Library Initialization
      • Troubleshooting SCSI Problems
      • Troubleshooting Fibre Channel Device Problems
    • Purchasing Additional Accessories
    • Purchasing Custom Bar Code Label Sequences
    • Purchasing CoD
      • To enable CoD
    • Fibre Channel Cable Requirements
    • SCSI Cable Requirements
    • SCSI Terminator Requirements
    • Sony AIT Tape Specifications
    • Sony AIT-2 Tape Drive Specifications
    • Sony AIT-3 Tape Drive Specifications
    • Power Requirements
      • Spectra 12000 Library
    • Operating Environment Limits
      • Acoustic Noise Limits
      • Shock and Vibration Specifications
      • Safety Standards
    • FCC Statement
    • EU Declaration of Conformity
    • Japan VCCI Class A Statement
    • Taiwan BSMI Statement
      • Opening the TAOS ITP Configuration Control Panel
      • Device Discovery
      • Installed Devices
      • Ethernet
      • Password
      • Control
      • Password Configuration
      • Fibre Configuration
      • Ethernet Configuration
      • TAOS ITP Configuration
      • TAOS NDMP Configuration
      • Enable Options
      • Save Changes
      • Discard Changes
      • Reboot
      • Help
      • Exit