Document Outline

• Introduction
  • About QualiPHY
  • About QPHY-10GBASE-T Option
  • Required Equipment
  • Required Host Computer System
  • Install Base Application
  • Activate Components
  • Set Up Dual Monitor Display
  • Set Up Remote Control
    • Configure Oscilloscope for Remote Control
    • Add Connection to QualiPHY
    • Select Connection
  • Accessing the Software
  • General Setup
    • Connection tab
    • Session Info tab
    • Report tab
    • Advanced tab
    • About tab
  • QualiPHY Test Process
    • Set Up Test Session
    • Run Tests
    • Run Reports
  • Customizing QualiPHY
    • Copy Configuration
    • Select Tests
    • Edit Variables
    • Edit Test Limits
  • X-Replay Mode
• QPHY-10GBASE-T Tx Testing
  • Test Preparation
    • Required Equipment
    • Required Test Modes
  • QPHY-10GBASE-T Tx Test Configurations
    • All Tests
  • QPHY-10GBASE-T Tx Test Descriptions
    • Test 1 - Maximum Output Droop
      • What Is Measured
      • Test Methodology
      • Default Pass Condition:
    • Test 2 - Transmitter Linearity
      • What Is Measured
      • Test Methodology
      • Default Pass Condition:
    • Test 3 - Transmitter Timing Jitter (Master)
      • What Is Measured
      • Test Methodology
      • Default Pass Condition:
    • Test 4 - Transmitter Clock Frequency
      • What Is Measured
      • Test Methodology
      • Default Pass Condition:
    • Test 5 - Transmitter Power Spectral Density
      • What Is Measured
      • Test Methodology
      • Default Pass Condition:
    • Test 6 - Transmitter Power Level
      • What Is Measured
      • Test Methodology
      • Default Pass Condition:
    • Test 7 - Transmitter Timing Jitter (SLAVE)
      • What Is Measured
      • Test Methodology
      • Default Pass Condition:
  • QPHY-10GBASE-T Tx Variables
    • Pairs To Test
  • QPHY-10GBASE-T Limit Sets
• QPHY-10GBASE-T Return Loss Testing
  • Test Preparation
    • Required Equipment
    • Required Test Modes
  • QPHY-10GBASE-T RL Test Configurations
    • All Tests
  • QPHY-10GBASE-T RL Tests
    • PreTest – Fixture Calibration
    • Test 1 – MDI Return Loss
      • What Is Measured
      • Test Methodology
      • Default Pass Condition:
  • QPHY-10GBASE-T RL Variables
    • Fixture De-Embedding Calibration File A
    • Fixture De-Embedding Calibration File B
    • Fixture De-Embedding Calibration File C
    • Fixture De-Embedding Calibration File D
    • Pairs To Test
  • QPHY-10GBASE-T RL Limit Sets
• Manual Deskewing Procedures
  • Cable Deskewing Using the Fast Edge Output
  • Cable Deskewing Without Using the Fast Edge Output
• Error Messages