Document Outline

• 2Head - Restricted Rights Notification for U.S. Government Users
• 2Head - Proprietary Material
• 2Head - Radio Frequency Interference Regulations
• 1Head - Overview
• 1Head - 326X Series Modem Family
  • 2Head - Product Family Model Numbers
• 1Head - Documentation Target Audience
• 1Head - Note to Programmers and System Developers
• 1Head - How to Use the Documentation Set
  • 2Head - 326X V.34 Series Modem User’s Guide (TEL–T0009)
  • 2Head - 326X Series Modem Reference Guide (TEL–09925)
• 1Head - References
• 1Head - Trademarks
• 1Head - Conventions
• 1Head - Special Notices
• 1Head - Messages spéciaux
• 1Head - Besondere Hinweise
• 1Head - Avisos Especiales
• 1TopHead - Introduction
• 1Head - Questions about Your Product Shipment
• 1Head - Technical Assistance or Scheduling Service
  • 2Head - Sales-Related Issues
  • 2Head - Comments about the Manual
• ChapTitle - About the Modem
  • 1TopHead - Introduction
    • 2Head - Safety and Operational Notices
  • 1Head - Operating the Modem from the Front Panel
  • 1Head - Selecting Programmed Option Sets
  • 1Head - Automatic Calling Interfaces (ACUs)
    • 2Head - AT ACU
    • 2Head - V.25bis ACU
    • 2Head - LPDA2 ACU
  • 1Head - Managing a Modem
  • 1Head - Restoring Data Transmission
  • 1Head - ITU-T V.34 Compliant Modulation Mode
  • 1Head - Synchronous Data Compression (SDC) Feature
  • 1Head - Automode/Multimode Feature
  • 1Head - Remote Configuration
  • 1Head - Error Correction and Data Compression
  • 1Head - Security
  • 1Head - Status Snapshots
  • 1Head - Adaptive Rate System
  • 1Head - Troubleshooting (V.54 and V.22bis Tests)
  • 1Head - Country-Specific Information
  • 1Head - NET Compliance
  • 1Head - CE Regulatory Marking Directive (93/68/EEC)
• ChapTitle - Installing the Modem
  • 1TopHead - Introduction
  • 1Head - Unpacking the Modem
  • 1Head - Additional Equipment Required
  • 1Head - Choosing a Site
  • 1Head - Connecting the Modem
    • 2Head - Rear Panel Connectors
    • 2Head - Ferrite Cylinders
    • 2Head - Cabling the Modem
    • 2Head - Connecting the Modem to a Network Management System
    • 2Head - Turning on the Modem
  • 1Head - Automatic Self-Test
  • 1Head - After Installing the Modem...
• ChapTitle - Getting Started
  • 1TopHead - Introduction
  • 1Head - System Requirements for Software Upgrades
  • 1Head - Configuring and Operating the Modem
    • 2Head - Using the Front Panel
    • 2Head - Navigating the Configuration Menu Tree
    • 2Head - Setting Configuration Options from the Front Panel
    • 2Head - Using the Modem with a Network Management System (NMS)
    • 2Head - Using the AT Automatic Calling Unit (ACU)
  • 1Head - Other Call Establishment Methods
    • 2Head - V.25bis ACU for Sync or Async Applications
    • 2Head - NetView LPDA-2 ACU for Sync Applications
    • 2Head - Sync Dialing from an IBM AS 400
    • 2Head - External Auto-Call Units
• ChapTitle - Configuring the Modem
  • 1TopHead - Overview
  • 1Head - Communications Software Package Operating Notes
    • 2Head - Configuring the Modem for Use with Communications Software
    • 2Head - Operating Notes
    • 2Head - If the Communications Software and Modem Do Not Operate...
  • 1Head - Preparing for Operation
    • 2Head - Reinitializing Memory from the Front Panel
    • 2Head - Reinitializing Memory Using the AT&F Command
  • 1Head - Configuration Option Sets
    • 2Head - What is an Option Set?
    • 2Head - Configuring an Option Set
    • 2Head - Option Set Defaults
  • 1Head - 326X V.32bis and 326XFAST Modem Application Examples
    • 2Head - Option Set 1—Async Calls to Central Site Using AT ACU
    • 2Head - Option Set 2—Sync Answering Central Site Without ACU
    • 2Head - Option Set 3—Sync Calls to Central Site, V.25bis ACU
    • 2Head - Option Set 4—Async Answering Central Site without ACU (Models 3260/62/65/67)
    • 2Head - Option Set 4—Synchronous Leased Line Applications with Dial Restoral (Models 3261/63/66/68)
  • 1Head - 326XFAST-SDC Modem Application Examples
    • 2Head - SDC Pre-Operation Notes
    • 2Head - Configuring the Modem for SDC Operation
    • 2Head - SDC Sample Applications
  • 1Head - Remote Access Reset
    • 2Head - Operation
    • 2Head - When Remote Access Reset Is Disabled
• ChapTitle - Using the AT Automatic Calling Interface
  • 1TopHead - Introduction
  • 1Head - What is the Attention (AT) Command Set?
    • 2Head - What Role Does Communications Software Play?
  • 1Head - Using AT Commands
    • 2Head - Entering AT Command Lines
    • 2Head - Autobaud Feature
    • 2Head - The Escape Sequence—(+++)
    • 2Head - Non-Configuration AT Commands
    • 2Head - S-Registers
• ChapTitle - Troubleshooting Guide
  • 1TopHead - Introduction
  • 1Head - Troubleshooting
  • 1Head - 326X Series Modem Diagnostic Tests
    • 2Head - Synchronous Data Compression (SDC) Testing
• AppTitle - Configuration Quick Reference
  • 1TopHead - Configuration Quick-Reference—Menu Trees
    • 2Head - For More Detail
    • 2Head - Audience and Assumptions
  • 1Head - Performing Numeric Entry
  • 1Head - S-Register/AT Command Cross-Reference
  • 1Head - Dial Modifiers for Special Dialing Requirements
  • 1Head - Result Codes
  • 1Head - Configuring the Modem’s Dual In-line Package (DIP) Switches
• AppTitle - Cabling and Interface Pinouts
  • 1TopHead - Introduction
  • 1Head - EIA/TIA 232-D (Modem to Computer) Interface
  • 1Head - ITU Recommendation V.35 Modem-to-Computer Interface
    • 2Head - ITU Rate V.35 Modem-to-Computer Interface Pinouts
    • 2Head - Differences, EIA/TIA 232-D and ITU Rate V.35 Interfaces
  • 1Head - DIAL LINE, LEASE (PRIVATE) LINE, PHONE Connector Pinouts
  • 1Head - NC (Network Control) Port Pinouts
  • 1Head - Cabling
    • 2Head - Cable Considerations
    • 2Head - DTE Cable Diagnostics
• AppTitle - Country-Specific Information
  • 1TopHead - Introduction
    • 2Head - Country Support
  • 1Head - Installation Notes
  • 1Head - Restricted Features Summary
  • 1Head - Operating Notes
  • 1Head - Standalone Modem Rear Panel Views
    • 2Head - 3260 Dial Only Modem
    • 2Head - 3261 Modem Rear View (Leased Line, Dial Restoral)
    • 2Head - 3265 Dial Only Modem
    • 2Head - 3266 Modem (Leased Line with Dial Restoral)
  • 1Head - Rear Panel Interface Pinouts
    • 2Head - Standalone Models 3260/65 and 3261/66 Interface Pinouts
    • 2Head - Card Models 3262/67, 3263/68 Backplane Interface Pinouts
  • 1Head - Delayed and Forbidden Lists
    • 2Head - Australia—Delayed Call Lists
    • 2Head - Austria—Forbidden Call Lists
    • 2Head - Belgium—Delayed Call Lists
    • 2Head - Finland—Delayed Call Lists
    • 2Head - France—Delayed and Forbidden Call Lists
    • 2Head - Hong Kong—Delayed Call Lists
    • 2Head - Ireland—Delayed Call Lists
    • 2Head - Netherlands—Delayed Call Lists
    • 2Head - Norway—Delayed Call Lists
    • 2Head - Spain—Delayed Call Lists
  • 1Head - Other Country-Specific Information
  • 1Head - Canada
    • 2Head - DOC Registration and Requirements
    • 2Head - Industry Canada Equipment Attachment Limitations
    • 2Head - Canadian Emissions Statement
    • 2Head - Rear Panel Pinouts
    • 2Head - Telco Option (AT&J)
  • 1Head - Denmark—Blind Dialing
  • 1Head - Hong Kong and United Kingdom—BABT Regulations
    • 2Head - Compliance with BS6328: Part 1: 1982 Section 8.3
    • 2Head - Compliance with BS6328: Part 1: 1982 Section 8.7
    • 2Head - Compliance with BABTSITS/82/01/C and BABT/SITS/ 82005S/D
    • 2Head - Compliance with BS6305 Clause 6.2, BS6320 Clause 7.2
    • 2Head - Ringer Equivalence Number (REN)
    • 2Head - Compliance with BABT/SITS/83/08/A Clause 1.2
    • 2Head - Compliance with BS6789: Section 6.1:1986 Clause 5.2
    • 2Head - Compliance with BS6789: Section 6.1:1986 Clause 7.3.1.3
    • 2Head - Compliance with BS6789: Section 6.1:1986 Clause 7.3.1.4
    • 2Head - Compliance with DTI 83/009I
    • 2Head - Compliance with BS6301
    • 2Head - Compliance with BABT SITS 83/009 Section D
  • 1Head - Installation of Telephone Socket
  • 1Head - Application for Installation of Telephone Socket
  • 1Head - U. S. A.
    • 2Head - FCC Registration
    • 2Head - FCC Regulations
    • 2Head - Dial Line Jack Types
    • 2Head - Rear Panel Pinouts
    • 2Head - Dial and Leased Line Transmit Levels
    • 2Head - Making Telephone-to-Modem Connections
    • 2Head - Telco Option (AT&J)
  • 1Head - Declaring The Jack Type
  • 1Head - Using the Modular Nest Backplane’s Busy Out Feature
• ChapTitle - Glossary
• ChapTitle - Return Procedures
  • 1Head - Equipment Return Procedures
    • 2Head - Expiration of Lease
    • 2Head - Factory Repair
    • 2Head - Packaging Guidelines for Equipment Return