Tweco Weld Sequencer Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for Weld Sequencer Tweco
Manuals
| Recognized languages: | English |
|---|---|
| Pages: | 66 |
| Size: | 1.37 MB |
Show table of contents
Read manual
Document Outline
- SECTION 1: GENERAL INFORMATION
- 1.01 Notes, Cautions and Warnings
- 1.02 Important Safety Precautions
- 1.03 Publications
- 1.04 Note, Attention et Avertissement
- 1.05 Precautions De Securite Importantes
- 1.06 Documents De Reference
- 1.07 Declaration of Conformity
- 1.08 Statement of Warranty
- SECTION 2: INTRODUCTION & DESCRIPTION
- 2.01 Scope of Manual
- 2.02 General Description
- 2.03 Specifications & Design Features
- SECTION 3: INSTALLATION PROCEDURES
- 3.01 Introduction
- 3.02 Site Selection
- 3.03 Unpacking
- 3.04 Equipment Installation - General
- 3.05 WT1 Weld Timer
- 3.06 GS1 Gas Slope
- 3.07 CS1 Current Slope
- 3.08 CP1 Pulser
- 3.09 Automatic Voltage Control (AVC) Lockout
- 3.10 Auxiliary Connections For Interfacing External Controls
- SECTION 4: OPERATION
- 4.01 Introduction
- 4.02 Functional Overview
- 4.03 Weld Sequencer Enclosure Control Descriptions
- 4.04 RP1 Control Descriptions
- 4.05 WT1 Weld Timer Control Descriptions
- 4.06 CS1 Current Slope Control Descriptions
- 4.07 CP1 Pulser Control Descriptions
- 4.08 GS1 Gas Slope Control Descriptions
- 4.09 Pre-Operation Setup
- 4.10 System Operation
- SECTION 5: CUSTOMER/OPERATOR SERVICE
- 5.01 Introduction
- 5.02 Transformer Connections
- 5.03 Troubleshooting Guide - General Information
- 5.04 Test Procedures
- 5.05 WT1 Weld Timer Parts Replacement Procedures
- SECTION 6: PARTS LIST
- 6.01 Introduction
- 6.02 Ordering Information
- 6.03 Weld Sequencer Enclosure
- 6.04 GS1 Gas Slope (Front Panel)
- 6.05 GS1 Gas Slope (Rear Panel)
- 6.06 CS1 Current Slope
- 6.07 CP1 Pulser
- 6.08 WT1 Weld Timer
- 6.09 RP1 Remote Pendant Control
- APPENDIX I: MOTION CONTROL & WIRE FEED INTERFACE DIAGRAM
- APPENDIX II: WELD SEQUENCER TERMINAL STRIP DIAGRAM
- APPENDIX III: AUXILIARY INTERFACE CONNECTION DIAGRAM
- APPENDIX IV: NECESSARY CONNECTIONS - RP-1 NOT USED WITH CS-1 WITH OR WITHOUT GS-1, WT-1 OR CP-1
- APPENDIX V: NECESSARY CONNECTIONS - RP-1 NOT USED WITH CP-1, WT-1 SYSTEM
- APPENDIX VI: TIMING AND SEQUENCE OF OPERATION FOR WELD SEQUENCER (ALL MODELS)
- APPENDIX VII: TIMING AND SEQUENCE OF OPERATION FOR GS1 GAS SLOPE ONLY
- APPENDIX VIII: SYSTEM SCHEMATIC