Document Outline

• DMT143 USER'S GUIDE
• Table of Contents
• GENERAL INFORMATION
  • About This Manual
    • Contents of This Manual
    • Version Information
    • Related Manuals
    • Documentation Conventions
  • Safety
    • ESD Protection
  • Recycling
  • Regulatory Compliances
  • Trademarks
  • License Agreement
  • Warranty
• PRODUCT OVERVIEW
  • Introduction to DMT143
  • Basic Features and Options
  • Transmitter Parts
    • Model with G1/2” ISO228/1 Thread
    • Model with NPT Thread
  • Loop-Powered Display
  • Connection Cables
  • Sampling Accessories
• FUNCTIONAL DESCRIPTION
  • DRYCAP® Technology
    • Auto-Calibration
    • Sensor Purge
    • Sensor Warming in High Humidities and Freezing Conditions
  • DMT143 Startup Sequence
  • Alarm LED
• INSTALLATION
  • Transmitter Configuration Before Installation
  • Selecting the Location
  • Installing the Transmitter
  • Wiring
    • Power Supply Requirements
  • Sampling from a Process
  • Sampling Accessories
    • DMT242SC Sampling Cell
    • DMT242SC2 Sampling Cell with Swagelok Connectors
    • DSC74 Sampling Cell with Quick Connector and Leak Screw
    • DSC74B Two-Pressure Sampling Cell
      • DSC74C Two-Pressure Sampling Cell with Coil
      • DM240FA Duct Installation Flange
• OPERATION
  • Transmitter Start-Up
  • Operation with DM70 Hand-Held Dewpoint Meter
  • Serial Communication
    • Connecting to the Serial Interface
      • Installing the Driver for the USB Service Cable
    • Terminal Application Settings
  • List of Serial Commands
  • Device Information
    • Show Device Information
    • Show Analog Output Mode
    • Show Firmware Version
    • Show Firmware Information
    • Show Currently Active Errors
    • Show Serial Number
    • Show Command List
  • Configuring Analog Output
    • Set Analog Output Parameters and Scaling
    • Set Analog Output Error Notification
    • Extend Analog Output Range
    • Test Analog Output
    • Enable or Disable Analog Output
  • Serial Line Output Commands
    • Start Measurement Output
    • Stop Measurement Output
    • Set Output Interval
    • Output a Reading Once
  • Configuring Measurement Parameters
    • Set Measurement Output Format
    • Set Measured Gas Type
    • Set Measurement Filtering
    • Set Pressure Compensation Value
    • Select Unit
    • View User Adjustment Parameters
    • Set User Adjustment Parameters
  • Configuring Serial Line Operation
    • Set Serial Line Operating Mode
    • Set Serial Line Settings
    • Set Transmitter Address
    • Set Serial Line Response Time
  • Other Commands
    • Opening the Transmitter in POLL Mode
    • Closing the Connection to a Transmitter in POLL Mode
    • Configure the Alarm LED
    • Show Transmitter Uptime
    • Reset Transmitter
    • Restore Factory Settings
• MAINTENANCE
  • Periodic Maintenance
    • Cleaning
    • Calibration
    • Changing the Filter
    • Field Check Using the DM70 Hand-Held Dewpoint Meter
  • Repair Maintenance
• TROUBLESHOOTING
  • Solving Typical Problems
  • Error Messages
  • Unknown Serial Settings
  • Technical Support
  • Product Returns
• TECHNICAL DATA
  • Specifications
  • Spare Parts and Accessories
  • Dimensions in mm