HP 1900ux - Manual (Page 44)

Navigation
44 HP StorageWorks 1000ux/1900ux/2300ux Optical Jukebox User’s Guide
Running an internal test
READY > ADMIN* > TEST*
This section describes self-diagnostic tests that are available on the jukebox.
Caution: Diagnostic tests should be run only by an authorized service
representative. Descriptions of the self-diagnostic tests are included in this
manual for information purposes only . If not properly completed, some of the
internal diagnostic tests can corrupt your file system. In some rare instances,
your service representative may request that you run specific tests to provide
information before they come to your site, or you may receive a control panel
message to run a specific test.
1. With READY displaying on the control panel, press NEXT until ADMIN*
displays.
2. Enter the administration password (see “ Entering the administration menu
password ” on page 44).
3. TEST* displays. Press ENTER.
4. Press NEXT until the name of the test you want to run displays and then press
ENTER to start the test.
—
*
MICROMOVE 6
#
Sixth jukebox micro-move for the original move
command issued prior to the failure. (This is the
last to be logged.)
■ *MICROMOVE ER #
Micro-move error that occurred.
■ TOP or BOTTOM
PICKER
Displays either
TOP
or
BOTTOM
indicating
which side of the disk transport mechanism was
active at the time of the error.
■ NORTH or SOUTH
THUMB
Displays either
NORTH
or
SOUTH
indicating
which thumb on the transport mechanism was
active at the time of the error.
Table 6: Information logs (Continued)
Log name Description