Flymo EasiCut 510 - Manual (Page 7)

How to Use
Caring for your Hedgetrimmer
• WARNING
Disconnect from the mains electricity supply, before
attempting any maintenance or adjustment.
Cleaning (P)
1.
Using a soft brush - remove debris from all air
intakes and cutting blade.
2. Wipe over surface of your hedge trimmer with a dry
cloth.
• IMPORTANT
Never use water for cleaning your hedge trimmer.
Do not clean with chemicals, including petrol, or
solvents - some can destroy critical plastic parts.
Lubricating the Cutting Blade
For easier operation and longer life, lubricate the cutter
blades before and after use. Apply the oil so that it runs
between the two blades. (R).
At the end of the Cutting Season.
1.
Clean your hedge trimmer thoroughly.
2. Check that all nuts and bolts are secure.
3. Visually inspect the hedge trimmer for any worn or
damaged parts, contact your local Service Centre if any
parts require replacement.
To store your hedge trimmer
•
Ensure the blade cover is fitted before storage.
• Store in a dry place where your hedge trimmer is
protected from damage.
P
R
How to Use your hedge trimmer
1. Inspect area to be cut before each use - remove
objects which can be thrown or become entangled in
the cutting blades.
2. Always keep the hedge trimmer in front of your body.
Hold handle firmly with both hands and stand in a
secure and stable position.
3. Allow the cutting blades to reach full speed before
entering the material to be cut.
4. Always work going away from people and solid objects
such as walls, large stones, trees, vehicles etc.
5. If blade stalls, immediately stop the hedge trimmer.
Disconnect the hedge trimmer from the power source
and clear jammed debris from the cutting blades.
Inspect blades and repair or replace as needed.
Top Cutting
Use a wide sweeping motion. (M) A slight downward tilt
of the cutting blades in the direction of motion gives the
best cutting results.
Side Cutting
When trimming the sides of the hedge, begin at the bottom and cut
upwards (N), tapering the hedge inward at the top. This shape will
expose more of the hedge, resulting in more uniformed growth.
M
N
Fault Finding Hints
Fails to Operate
1. Is the Power Turned On?
2. Check the fuse in the plug, if blown replace.
3. Fuse continues to blow?
Immediately disconnect from the mains electricity
supply and consult your local approved Service
Centre.
Cutting blade stops under load
1. Cut at a slower pace.
2. If cutting blade still stops under load?
Disconnect from the mains electricity supply and
consult your local approved Service Centre.
Fails to stop when one switch lever is released.
Immediately disconnect from the mains electricity
supply and consult your local approved Service
Centre.
Poor cut quality
1. Ensure the product is being used correctly (see How
to Use)
2. Ensure blades are free from trapped debris
3. Damaged Blades?
Immediately disconnect from the mains electricity
supply and consult your local approved Service
Centre.
Excessive Vibration
Immediately disconnect from the mains electricity
supply and consult your local approved Service
Centre.