2 rear connection panel, Rear connection panel – FOCUS Enhancements FS-2 User Manual

Page 30

Advertising
background image

Introduction

FS-2/2E Studio DTE Disk Recorder User Guide

10

1.8.2 Rear Connection Panel

The FS-2/2E rear panel, shown below, contains control and audio/video

input/output areas described in this section.
You can select any of the available inputs as a source. When selected, that

source is what is recorded to disk. If the unit is in E-E mode or recording, all

outputs are live with the incoming signal.
For any particular video input, there is an associated audio input selected as

a default. You can change that default to another input utilizing the

AUDIO

INPUT MENU

under

SETUP

. Refer to Chapter 2 for more information.

1. GPI

- For connection of the optional wired remote control (ACSS-0019-

01), the optional RS232C cable (CBLA-0113-01) or contact closure

cable. The GPI plug accepts a 3.5mm TRS connector.

2. Front Panel HDD Port Loop Through

- When patched to the

To HDD

port, this connector activates the front panel FireWire port for

connection of external HDDs.

3. RS422 Control

- This is the input connector for external RS422 control

devices.

4. SDI Input

- For connecting SDI input sources. The FS-2E provides the

selection of channels 1 and 2 or 3 and 4 of the embedded SDI audio.

Refer to the

AUDIO INPUT > SDI > EMBEDDED

sub-menu on

Audio

Input

on page 59. The FS-2 does not have this capability.

SDI Output

- For output to SDI devices. The FS-2E inserts two channels

of audio into the SDI output stream. Only the FS-2E has this capability.

5. Y/C Input

- For connecting

Y/C

(S-Video) input sources.

Y/C Output

- For connecting to

Y/C

(S-Video) devices.

6. Composite / Y Input

- For connecting composite input sources or the

Y

signal for component input sources.

Composite / Y Output

- For output to composite devices or the

Y

signal

to component devices (select either composite or component form

ANALOG SETTINGS

in the

SETUP

menu).

7. Pb Input

- For connecting the Pb signal from component input sources.

Pb Output

- For output of the Pb signal to component devices.

1

2

20

3

4

5

6

7

8

16

9

10 11 12

13

14

15

19 18

17

Advertising
This manual is related to the following products: