Foundry Networks AR3202-CL - Manual (Page 140)

OSPF Configure Commands
June 2004 © 2004 Foundry Networks, Inc. 9 - 29
configure router ospf interface network
This command configures the OSPF network type on an interface.
Parameter Description
syntax:
[ no ] network < broadcast | non_broadcast | point_to_multipoint | point_to_point >
NOTE: If the interface type is point-to-point, then to change the network type to broadcast, the user must first
change the point-to-point interface to broadcast type using the ip address command.
NOTE: The “non_broadcast” and “point_to_multipoint” parameters are not supported in this release.
example:
Foundry-AR1208/configure/router/ospf/interface toBoston# network non_broadcast
related commands:
interface type network type default
PPP/HDLC point-to-point
Ethernet broadcast
Frame Relay point-to-point
network type
broadcast Configures network type to broadcast multi-access network
non_broadcast Configures network type to nonbroadcast multiaccess (NBMA)
network
point_to_multipoint Configures network type to point-to-multipoint network
point_to_point Configures network type to point-to-point network
configure router ospf interface authentication
configure router ospf interface cost
configure router ospf interface dead_interval
configure router ospf interface hello_interval
configure router ospf interface neighbor
configure router ospf interface poll_interval
configure router ospf interface priority
configure router ospf interface retransmit_interval
configure router ospf interface transmit_delay