First Alert FA120C - Manual (Page 34)

Р 3 4 Р
SUMMARY OF AUDIBLE/VISUAL NOTIFICATIONS
S O U N D C A U S E D I S P L A Y
LOUD, INTERRUPTED
Keypad & External
FIRE ALARM FIRE and ALARM are displayed; protection zone in alarm is displayed.
LOUD, CONTINUOUS
Keypad & External
BURGLARY/AUDIBLE
EMERGENCY ALARM ALARM is displayed; protection zone in alarm is also displayed.
ONE SHORT BEEP
(not repeated)
Keypad only a. SYSTEM DISARM
b. SYSTEM ARMING ATTEMPT
WITH AN OPEN ZONE
c. BYPASS VERIFY
a. Only READY is displayed. Green READY indicator (if present) is lit.
b. NOT READY is displayed, open protection zone number is displayed.
Green READY indicator (if present) is not lit.
c. The bypassed protection zone numbers are displayed. (One beep for each number
displayed.) BYPASS also displayed.
ONE SHORT BEEP
(once every 40 seconds)
Keypad only SYSTEM IS IN TEST MODE Opened Zone identifications will appear.
ONE BEEP every 40 sec.
Keypad only a. LOW BATTERY AT XMTR
b. TROUBLE a. BAT displayed with ID number of transmitter.
b. CHECK displayed. Troubled protection zone is displayed.
TWO SHORT BEEPS
Keypad only ARM AWAY OR MAXIMUM AWAY and (if MAXIMUM) INSTANT are displayed.
THREE SHORT BEEPS
Keypad only a. ARM STAY OR INSTANT
b. ZONE OPENED WHILE SYS-
TEM IS IN CHIME MODE
c. ZONE OPENED WHILE SYS-
TEM IS IN TEST MODE
a. STAY and (if INSTANT) INSTANT are displayed. Red ARMED indicator is lit.
b. CHIME displayed. Pressing ✴/ READY key will display opened zone.
c. Open protection zone number is displayed.
RAPID BEEPING
Keypad only MEMORY OF ALARM FIRE and/or ALARM is displayed; zone in alarm is displayed.
SLOW BEEPING
Keypad only ENTRY DELAY WARNING None during delay; Exceeding the delay time without disarming causes alarm.
If bell is used as external sounder, fire alarm is pulsed ring; burglary/audible emergency is steady ring.
N o t e s : ¥ BAT displayed (with no beeping or zone number) indicates system main battery is weak (see page 27).
¥ Also see
Power Failure, and Other Displays under TROUBLE CONDITIONS on page 27.