Installation instructions, Before you begin, Important – GE 197D7188P001 User Manual

Page 8: Warning, Warnings

Advertising
background image

BEFORE YOU BEGIN

Read these instructions completely and carefully.

IMPORTANT –

Save these instructions

for local inspector’s use.

IMPORTANT –

Observe all governing

codes and ordinances.

Note to Installer –

Be sure to leave these

instructions with the Consumer.

Note to Consumer –

Keep these instructions

for future reference.

WARNING –

This appliance must be

properly grounded. See “Electrical Supply.”

If you received a damaged wine chiller or beverage

center, you should immediately contact your dealer
or builder.

• Skill Level – Installation requires basic mechanical

skills. Proper installation is the responsibility of the
installer. Product failure due to improper installation
is not covered under the GE Appliance Warranty.

Questions? Call 800.GE.CARES (800.432.2737)

or

Visit our Website at:

ge.com

Installation

Wine Chiller and

Instructions

Beverage Center

• Use this appliance only for its intended purpose.
• Immediately repair or replace electrical service cords that

become frayed or damaged.

• Unplug the unit before cleaning or making repairs.
• Repairs should be made by a qualified service technician.

WARNINGS:

8

10" Minimum

to Wall

110

°

PRODUCT CLEARANCES

• The door swing is reversible on all models. If desired,

change the door swing before installation.

Choose the location:

• These products may be closed in on the top and three

sides as long as the front is unobstructed for air circulation
and proper access to the door.

• Do not install these products where the temperature will go

below 55°F (13°C) or above 90°F (32°C).

• Do not install where it will be subject to direct sunlight, heat

or moisture.

• These products are not designed to be stacked one over

the other.

The wine chiller and beverage center is factory set for a
110° door swing.

When installed in a corner:

• Allow 4

″ min. clearance on the hinge side for the 90° door

swing and to allow racks to slide out.

• Allow 10

″ minimum clearance on the hinge side for a full

110° door swing.

21-5/8"

23-5/8"

4" Minimum

to Wall

90

°

90° Door Swing

Advertising
This manual is related to the following products: