GE JKP7027 - Manual (Page 9)

Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
Using the clock and timer.
GEAppliances.com
9
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle. Press the Clock pad.
On models with number pads, press
them in order to set the correct time
of day.
On models with Hour and Min +
and – pads, press them to set the
correct time of day.
Press the Start pad.
Make sure the clock is set to the
correct time of day.
To Set the Timer
Press the Kitchen Timer On/Off pad.
On models with number pads, press
them until the amount of time you
want shows in the display. For
example, to set 2 hours and 45
minutes, press 2, 4 and 5 in that
order.
On models with Hour and Min +
and – pads, press them until the
amount of time you want shows in
the display. The maximum time you
can enter in minutes is 59. Cooking
times more than 59 minutes should
be changed to hours and minutes.
For example, enter 90 minutes as
1 hour, 30 minutes.
If you make a mistake, press Kitchen
Timer On/Off and begin again.
Press the Start pad.
After pressing the Start pad, SET disappears;
this tells you the time is counting down, although
the display does not change until one minute
has passed. Seconds will not be shown in the
display until the last minute is counting down.
When the timer reaches :00, the
control will beep 3 times followed
by one beep every 6 seconds until
the Kitchen Timer On/Off pad
is pressed.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59 minutes.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by pressing
the Kitchen Timer On/Off pad, then press
the number pads (on some models) or
the Hour and Min + or – pads (on some
models) until the time you want appears
in the display. If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
pressing the Kitchen Timer On/Off pad and
then pressing the number pads (on some
models) or the Hour and Min + or – pads
(on some models) to enter the new time
you want.
To Cancel the Timer
Press Kitchen Timer On/Off pad twice.