MB QUART ZUR65IC - Manual (Page 5)

4
DIAGRAM 4
IN-WALL SPEAKER PLACEMENT (ZUR5.25IW / ZUR6.5IW)
These speakers are designed to operate in a standard drywall or wood paneling type wall.
The speakers feature removable back enclosure half that permits extremely shallow mounting conditions
when necessary. You can mount the speakers vertical or horizontal and may be used for left / right
main speakers or center channel as well as mirror imaged set-up.
1. Choose mounting locations that are equal distance left and right of the listening area as shown
in DIAGRAM 4.
2. Use the speaker cut-out template supplied to mark your hole locations.
(Be sure there is clearance behind the area you have chosen for the speaker. Avoid electrical wiring,
plumbing, moving parts, air ducts and Fire Stops.
3. Use a drywall saw or other appropriate tool to carefully cut out the speaker holes. The cut-out is the
exact size required for the speaker. You also can go as much as 1/4” over this size as “Mistake Room”.
4. Connect the speaker wires (16 gauge wire not supplied) to the speakers as shown in DIAGRAM 5.
(Be sure to get the + and - polarity correct)
5. Place the speaker into the speaker opening and using a # 2 phillips screw driver, turn the Dog-Ear
fastening screws clockwise (be sure to support the weight of the speaker until all Doq-Ear screws
are securely tightened).
The Doq-Ear Clamp will rotate away from the speaker enclosure and begin to tighten against the mounting
surface to secure the speaker as shown in DIAGRAM 6.
6. Carefully route the speaker wires to the amplifier or other power source. Be sure to avoid moving parts,
heat producing items and water exposure.
LEFT
FRONT
CENTER
RIGHT
FRONT
TV
RIGHT
REAR
LEFT
REAR
5.1 or 7.1
System