Mustek KB4000 - Manual (Page 10)

type, each finger print has a central area around which the remainder of the
pattern is distributed. This central area is the core of the finger print. Best
performance is achieved when the core of the finger print is placed in the center
of the sensor detection surface. It is essential to place the core of finger print
inside the sensor area to obtain a successful image capture of the finger print.
It is most advisable in real practice to register (enroll) for each ID more
than 1 finger and even better to register fingers from both hands into the system.
In this way, the identification procedure can less likely be obstructed even in
case of accidental injury. Please note that the finger print sensor is not suitable
for taking the finger print image of an infant.
Please refer to the readme files in the software installation for further
detail or consult our web site http://www.posiflex.com.tw
MAGNETIC STRIPE READER
The regular magnetic stripe reader in KP100 or KB4000 connects to the
host through KB port and therefore requires no driver installation to get it
working. The regular magnetic stripe reader in SD100 connects to the host
through USB port working as a USB KB and therefore also requires no driver
installation except setting up the USB keyboard to be enabled in system CMOS
setup. However for the special MSR type in SD100 that utilizes a MSR
connector, it relies on the controller inside the MSR port of the host to
consolidate the MSR data into KB port of the system.
Besides the interface options there are also reader head options applicable
to MSR in these security devices. The reader head can be JIS II type or one of
the possible configurations in ISO standard (tracks 1 & 2, 2 & 3, 1 & 2 & 3). For
ISO MSR, some parameters on data readout can be set by jumper setting or by
software provided by Posiflex as below. For MSR to read card of AAMVA and
CA DMV, the reader head must be 3 tracks ISO type and it must be on KB4000
or KP100 or it has to be the USB interface type in SD100.
To manipulate the ISO MSR
in SD100, one has to alter the jumper
settings on the controller board in the
2
1
12
JP1 11 CN1 CN2 CN3
U1 U3
U5
KB4000 Series User’s Manual 3 - 2