Magellan RoadMate 1415 - Manual (Page 45)

Traffic 36
Dist. to event < 40 mi: With this option checked, the receiver will re-route you only if the
distance to this Traffic event, is less than 40 miles from your current location (not a point-
to-point distance but that measured along the route).
Dist. to event < 20 miles: Same as above for a distance of 20 miles.
Dist. to event < 10 miles: Same as above for a distance of 10 miles.
7. Select Save to confirm your choice and then Save again to return to your guidance screen.
Traveling with the Re-routing Mode On
The following will occur whenever a Traffic event that affects your route is received:
• The receiver will analyze the impact this event will have on your route.
• A “Re-calculating the route” message will pop up on the screen along with the reason for
the re-calculation.
• Once the alternate route has been computed, it will compare the alternative route with the
original route, and will decide which is the best route to follow, taking time and distance
into consideration.
• If the original route is still the best one to follow, the route will be unchanged, and the
time portion of the status bar will be updated to reflect the delay. The traffic icon will
appear in the lower right corner of the map display. Tapping this icon brings up a list of
the traffic events on the route.
• If the alternative route is the best route to follow, the receiver will start guiding you along
this route.
• The map screen will also show road signs corresponding to Traffic events, including those
not affecting the route.
• Events that affect your route will also appear as road signs in the maneuver list.
Alert Only Mode
This mode will not provide you with new routing information, it will only alert you to the event.
1. Access the Main Menu and select User
Options.
2. Scroll down the list and select Traffic Options
3. Select
Traffic Selection.
4. Check the
Traffic Active option and make sure the Use alternative route option is deselected.
5. Select the
Alert Options button on the screen.
A new screen appears on which you can set
the options relevant to the Alert mode.
Check one or more of the following options:
Live Alert: When checked, the receiver will
inform you of a traffic event located along
your route as soon as it is detected.
Reminder at 40 mi: If you check this option, the
receiver will remind you of the traffic event it has received earlier. The message will appear
when this event, located somewhere along your route, is 40 miles away from your current
location (not a point-to-point distance but measured along the route).