Motorola S1201 - Manual (Page 30)

30 Help
2. Press
m
. All the bases that your handset has been
registered to will be displayed, e.g. BASE 1 2 3 4 . The
currently selected base number flashes.
3. Enter the base number that you want to use.
Alternatively, press
u
or
d
to scroll to AUTO .
4. Press
m
to confirm. You will hear a confirmation beep
and the display will return to the previous menu.
NOTE
If you select
AUTO , your handset will automatically search for
and connect to the base with the strongest signal.
9.4 De-register a handset
Use one handset to de-register another. You cannot
de-register the handset that you are using.
1. Press
m
, scroll
d
to SETUP and press
m
.
2. Scroll
d
to DEL HANDSET and press
m
.
3. Enter the 4 digit PIN code (default = 0000) and press
m
.
4. Enter the handset number that you want to de-register.
You will hear a confirmation beep and the display will
return to the previous menu.
10. Help
No dial tone
• Use only the telephone line cord supplied.
• Check that the telephone line cord is connected properly.
• Check that the mains power is connected properly and
switched on.
No display
• Check that the batteries are inserted correctly and fully
charged. Use only approved rechargeable batteries
supplied.
• Check that the handset is switched on. Press and hold
n
.
• Reset the base by removing the batteries and
disconnecting the mains power. Wait for around 15
seconds before connecting it again. Allow up to one
minute for the handset and base to synchronize.
icon flashes
• Handset is out of range. Move closer to the base.
• Make sure that the handset is registered to the base, see
page 28.
• Check that the mains power is connected properly and
switched on.
Keypad does not seem to work
• Check that the keypad lock is not on, see page 17.