Miele DAG 1000 - Manual (Page 37)

,WARNING
TO REDUCE THE RISK OF
FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
All electrical work should be
performed by a qualified electrician
in strict accordance with national
regulations and local safety
regulations.
Installation, repairs and other work
by unqualified persons could be
dangerous.
Ensure that power to the appliance
is off while installation or repair work
is performed.
The ventilation system may only be
used with Miele DAG 500 or
DAG 1000 blowers.
^ Verify that the voltage, load and
circuit rating information found on the
data plate, match the household
electrical supply before installing the
ventilation system.
If there is any question concerning the
electrical connection of this appliance
to your power supply, please consult a
licensed electrician or contact Miele’s
Technical Service Department. See
back cover for contact information.
WARNING:
THIS APPLIANCE MUST BE
GROUNDED
^ If you have not yet done so, remove
the cover of the terminal box.
^ Install a suitable UL listed cable
clamp or conduit fitting at the cable
knock-out.
^ Pass the power supply cable through
the knock-out of the housing into the
terminal box.
Important
The ventilation system must be hard
wired as follows:
Black wire: . . . . . . . connect to L1 (live)
White wire: . . . . . connect to N (neutral)
Green-yellow wire: . . . connect to GND
. . . . . . . . . . . . . . . . . . . . . . . . . (ground)
Electrical connection
37