MACKIE 8-Channel - Manual (Page 6)

6
PPM608
PPM608
Hookup Diagrams
Club System
Powered Subwoofers
(plays main mix below 100 Hz)
Microphones
press HI-Z
button
Keyboards
SRM450v2 Powered Stage Monitors
(plays mon 1 output)
Portable Recorder
Rear Panel
Front Panel
Power Amp Mode
switch set to
Stereo Main
Adjust
Vocal
Compression
press HI-Z
button
Passive Speakers
(plays stereo main mix)
This diagram shows microphones attached to channels 1 and 2, electric guitars connected directly to
channels 5 and 6 (with hi-z switch pressed in), and a keyboard attached to channel 7's stereo inputs. A
portable recorder is attached to the stereo tape outputs to record the performance.
Mackie SRM450v2 powered speakers are connected to the monitor 1 send, and are set up as stage
monitors. The mon 1 controls of each channel allow you to create a stage monitor mix that is indepen-
dent of the main mix. Use the monitor 1 graphic EQ to adjust the stage monitor EQ as desired.
Passive speakers are connected to the speaker-level power output of the powered mixer, and they play
the main stereo mix to your audience. Powered subwoofers are connected to the main mix sub out, to
reinforce the low end in your system.