Start-up and use, Starting the appliance, Setting the temperature – Indesit SAN 300 User Manual
Page 7: Chiller system
GB
7
Start-up and use
Starting the appliance
! Before starting the appliance, follow the installation
instructions (see Installation).
! Before connecting the appliance, clean the
compartments and accessories well with lukewarm water
and bicarbonate.
1. Insert the plug into the socket and ensure that the
internal light illuminates.
2. Turn the TEMPERATURE ADJUSTMENT knob to an
average value. After a few hours you will be able to put
food in the refrigerator.
Setting the temperature
The temperature inside the refrigerator compartment
automatically adjusts itself according to the position of the
thermostat knob.
= warmest
= coldest
We recommend, however, a medium position.
The cooling section of the refrigerator is located inside the
back wall of the refrigerator compartment for increased
space and improved aesthetics. During operation, the
back wall will be covered in frost or water droplets
depending on whether the compressor is operating or
paused. Do not worry, the refrigerator is functioning
normally.
Chiller system
The appliance comes with one of the chiller systems
described below: take note of your system in order to
determine the most efficient food storage method.
Aircooler
It is recognizable due to the presence of the mechanism
on the top part of the refrigerator compartment (see
diagram).
A
B
The Aircooler maintains a constant fridge temperature to
keep food fresher for longer and will quickly restore the
temperature to the correct level, even if the door is opened
frequently: the blown air (A) is cooled when it comes into
contact with the cold wall, whereas the hotter air (B) is
sucked up (see diagram).
The back wall may be covered in frost or droplets of water,
depending on whether the compressor is in operation or
whether it is paused.
Static
Models without the Aircooler. have the cooling section in
the internal back wall of the compartments. The wall will be
covered in frost or water droplets depending on whether
the compressor is operating or paused: both cases are
normal. If the TEMPERATURE ADJUSTMENT knob has
been set on high values with large quantities of food and
with a high ambient temperature, the appliance can
operate continuously, resulting in excessive frost formation
and excessive energy consumption: compensate for this
by shifting the knob towards lower values (defrosting will
occur automatically).
In static appliances, the air circulates in a natural way: the
colder air tends to move downwards as it is heavier. The
food should be stored as follows:
)RRG
$UUDQJHPHQW LQVLGH WKH
UHIULJHUDWRU
Fresh fish and meat
Above the fruit and vegetable
bins
Fresh cheese
Above the fruit and vegetable
bins
Cooked food
On any shelf
Salami, bread loaf,
chocolate
On any shelf
Fruit and vegetables
In the fruit and vegetable bins
Eggs
On the shelf provided
Butter and margarine On the shelf provided
Bottles, drinks, milk
On the shelf provided