IBM VT670 - Manual (Page 31)

24
3. Projecting an Image (Basic Operation)
Place your projector on a flat level surface and ensure that the projector is
square to the screen.
Lift the front edge of the projector to center the image vertically.
*
If the projected image does not appear square to the screen then use the
Keystone feature for proper adjustment. See page
26 .
ᕣ Adjusting the Picture Size and Position
AC I N
ZOOM
FOCU S
AC IN
ZOOM
FOC US
Adjust the Tilt Foot
1. Lift the front edge of the projector.
2. Push up the Adjustable Tilt Foot Levers on the right and left sides
of the projector to extend the adjustable tilt feet (maximum height).
3. Push down the Adjustable Tilt Foot Levers.
4. Lower the front of the projector to the desired height and release
the Adjustable Tilt Foot Lever to lock the Adjustable tilt foot. There
is approximately 10 degrees of up and down adjustment for the
front of the projector.
CAUTION
Do not use the tilt-foot for purposes other than originally intended. Misuses
such as gripping the tilt-foot or hanging on the wall can cause damage to the
projector.
2
ZO OM
FO CU S
SE LE CT
LA MP ST AT US PO WE R VID EO S-V ID EO CO MP UT ER -1 CO MP UT ER -2
ON /S TA ND B Y
AUTO ADJ.
1
2
ZOOM
FO CU S
SELECT
LAMP STATUS POWER
VIDEO
S-VIDEO
COM PUTER-1 COMPU TER-2
ON/STAND BY
AU TO AD J.
3
4
4
Adjustable Tilt Foot
Move the projector left to center the image horizontally on the screen.
Adjustable Tilt
Foot Lever
Adjustable Tilt
Foot Lever