Setup utility program – IBM 6341 User Manual
Page 18
Setup Utility program
Attention:
A customized setup configuration (other than default settings) might exist on the computer
you are servicing. Running the Setup Utility program might alter those settings. Note the
current configuration settings and verify that the settings are in place when service is
complete.
The Setup Utility (configuration) program is stored in the permanent memory of
the computer. This program includes settings for the following:
v System Summary
v Product Data
v Devices and I/O Ports
v Start Options
v Date and Time
v System Security
v Advanced Setup
v Power Management
To run the Setup Utility program, use the following procedure.
1.
Power-off the computer and wait for a few seconds until all in-use lights go off.
2.
Power-on the computer.
3.
When the Setup Utility prompt appears on the screen during start-up, press F1.
The Setup Utility menu will appear.
4.
Follow the instructions on the screen.
5.
When finished, select System Summary to verify that any configuration
changes have been accepted.
10
Hardware Maintenance Manual