Diagnostic error codes – IBM 6341 User Manual
Page 80
Diagnostic error codes
Refer to the following diagnostic error codes when using the diagnostic tests. See
″Diagnostics″ on page 9 for the specific type for information about the Diagnostic
programs.
In the following index, X can represent any number.
Diagnostic Error Code
FRU/Action
000-000-XXX
BIOS Test Passed
1.
No action
000-002-XXX
BIOS Timeout
1.
Flash the system
2.
System board
000-024-XXX
BIOS Addressing test failure
1.
Flash the system
2.
System board
000-025-XXX
BIOS Checksum Value error
1.
Flash the system
2.
Boot block
3.
System board
000-026-XXX
FLASH data error
1.
Flash the system
2.
Boot block
3.
System board
000-027-XXX
BIOS Configuration/Setup error
1.
Run Setup
2.
Flash the system
3.
Boot block
4.
System board
000-034-XXX
BIOS Buffer Allocation failure
1.
Reboot the system
2.
Flash the system
3.
Run memory test
4.
System board
000-035-XXX
BIOS Reset Condition detected
1.
Flash the system
2.
System board
000-036-XXX
BIOS Register error
1.
Flash the system
2.
Boot block
3.
System board
000-038-XXX
BIOS Extension failure
1.
Flash the system
2.
Adapter card
3.
System board
000-039-XXX
BIOS DMI data error
1.
Flash the system
2.
System board
000-195-XXX
BIOS Test aborted by user
1.
Information
2.
Re-start the test, if necessary
000-196-XXX
BIOS test halt, error threshold exceeded
1.
Press F3 to review the log file
2.
Re-start the test to reset the log file
72
Hardware Maintenance Manual