JVC KD-R311 - Manual (Page 29)

3
1 2 3 Repeat step 2 if necessary.
• To return to the previous menu, press BACK.
• To exit from the menu, press DISP or MENU.
Category Menu item Selectable setting, [ Initial: Underlined ]
DEMO
DEMO • DEMO ON
• DEMO OFF
: Display demonstration will be activated automatically if
no operation is done for about 20 seconds.
: Cancels.
CLOCK
CLOCK SET [ 1:00 ] : Adjust the hour, then the minute.
PRO EQ
BASS — : For settings, see “Storing your own sound mode.”
MIDDLE
TREBLE
DISPLAY
DIMMER • DIMMER ON
• DIMMER OFF : Dims the display and button illumination.
: Cancels.
SCROLL * 1 • SCROLL ONCE
• SCROLL AUTO
• SCROLL OFF : Scrolls the displayed information once.
: Repeats scrolling (at 5-second intervals).
: Cancels.
Pressing DISP for more than one second can scroll the display regardless of the
setting.
TAG
DISPLAY • TAG ON
• TAG OFF
: Shows the Tag information while playing MP3/WMA
tracks.
: Cancels.
TUNER
SSM * 2 • SSM 01 – 06
• SSM 07 – 12
• SSM 13 – 18 : For settings, see “Automatic presetting (FM)—SSM
(Strong-station Sequential Memory)” on page 2.
AREA • AREA US
• AREA EU
• AREA SA
: When using in North/Central/South America. AM/FM
intervals are set to 10 kHz/200 kHz.
: When using in any other areas. AM/FM intervals are set
to 9 kHz/50 kHz (100 kHz during auto search).
: When using in South American countries where FM
interval is 100 kHz. AM interval is set to 10 kHz.
MONO * 2 • MONO ON
• MONO OFF
: Activate monaural mode to improve FM reception, but
stereo effect will be lost.
: Restore the stereo effect.
IF BAND • AUTO
• WIDE
: Increases the tuner selectivity to reduce interference
noises between adjacent stations. (Stereo effect may be
lost.)
: Subject to interference noises from adjacent stations,
but sound quality will not be degraded and the stereo
effect will remain.
Category Menu item Selectable setting, [ Initial: Underlined ]
AUDIO
FADER * 3 R06 – F06 [ 00 ] : Adjust the front and rear speaker output balance.
BALANCE * 4 L06 – R06 [ 00 ] : Adjust the left and right speaker output balance.
LOUD • LOUD ON
• LOUD OFF
: Boost low and high frequencies to produce a well-
balanced sound at a low volume level.
: Cancels.
VOL ADJUST VOL ADJ –05 —
VOL ADJ +05
[VOL ADJ 00]
: Preset the volume adjustment level of each source
(except FM), compared to the FM volume level. The
volume level will automatically increase or decrease when
you change the source.
• Before making an adjustment, select the source you
want to adjust.
• “VOL ADJ FIX” appears on the display if “FM” is selected
as the source.
L/O MODE • SUB.W
• REAR
: Select if the REAR LINE OUT terminals are used for
connecting a subwoofer (through an external amplifier).
: Select if the REAR LINE OUT terminals are used for
connecting the speakers (through an external amplifier).
SUB.W
FREQ *
5
• LOW
• MID
• HIGH : Frequencies lower than 72 Hz are sent to the subwoofer.
: Frequencies lower than 111 Hz are sent to the subwoofer.
: Frequencies lower than 157 Hz are sent to the subwoofer.
SUB.W
LEVEL *
5
SUB.W 00 —
SUB.W 08
[ SUB.W 04 ] : Adjust the subwoofer output level.
BEEP • BEEP ON
• BEEP OFF : Activates the keypress tone.
: Deactivates the keypress tone.
AMP GAIN * 6 • LOW POWER
• HIGH POWER
: VOLUME 00 – VOLUME 30 (Select if the maximum power
of each speaker is less than 50 W to prevent damaging the
speakers.)
: VOLUME 00 – VOLUME 50
SRC
SELECT
AM * 7 • AM ON
• AM OFF : Enable “AM” in source selection.
: Disable “AM” in source selection.
AUX IN * 8 • AUX ON
• AUX OFF : Enable “AUX IN” in source selection.
: Disable “AUX IN” in source selection.
* 1 Some characters or symbols will not be shown correctly (or will be blanked) on the display.
* 2 Displayed only when the source is “FM.”
* 3 If you are using a two-speaker system, set the fader level to “00.”
* 4 This adjustment will not affect the subwoofer output.
* 5 Displayed only when <L/O MODE> is set to <SUB.W>.
* 6 The volume level automatically changes to “VOLUME 30” if you change to <LOW POWER> with the volume level
is set higher than “VOLUME 30.”
* 7 Displayed only when any source other than “AM” is selected.
* 8 Displayed only when any source other than “AUX IN” is selected.
Menu operations
Selecting a preset sound mode
You can select a preset sound mode suitable for the music genre.
FLAT
= NATURAL = DYNAMIC =
VOCAL BOOST
= BASS BOOST =
USER
= (back to the beginning)
While listening, you can adjust the tone level of the selected sound
mode.
1
2
Adjust the level (–06 to +06) of the selected tone (BASS /
MIDDLE / TREBLE).
The sound mode is automatically stored and changed to “USER.”
Storing your own sound mode
You can store your own adjustments in memory.
1
2
] <PRO EQ> ] <BASS> / <MIDDLE> / <TREBLE>
3
Adjust the sound elements of the selected tone ( see table on
the right).
4 Repeat steps 2 and 3 to adjust other tones.
The adjustments made will be stored automatically in “USER.”
The current sound mode changes to “USER” automatically.
Tone
Sound element
Frequency Level Q
BASS 60 Hz, 80 Hz, 100 Hz,
200 Hz –06 to +06 Q1.0, Q1.25,
Q1.5, Q2.0
MIDDLE 0.5 kHz, 1.0 kHz,
1.5 kHz, 2.5 kHz –06 to +06 Q0.75, Q1.0,
Q1.25
TREBLE 10.0 kHz, 12.5 kHz,
15.0 kHz, 17.5 kHz –06 to +06 Q FIX
[Hold]
[Hold]
[Hold]
EN_KD-R418[J]f.indd 3 EN_KD-R418[J]f.indd 3 10/23/09 2:30:40 PM 10/23/09 2:30:40 PM