JVC GM-V42PCE - Manual (Page 25)

24
Other Convenient Functions
V I D E O A
N T S C
C O M P O N E N T
4 8 0 i
R G B B ( B N C )
3 7 . 9 k H z 6 0 . 3 H z *
Input Video signal
type
Ex. When selecting “COMPONENT” input
When the signal being input is a preset video
mode, an “*” will be shown after the
frequency.
Ex. When selecting “VIDEO A” input
To set the other convenient functions, use menus.
You can use the buttons either on the remote control or on
Monitor for menu operations.
• Refer also to “Menu Classifications” on pages 34 and 36.
Showing On-screen Display
The input mode and signal type will be indicated on the
screen.
• The following procedure can be done by using the buttons
on the Monitor. You can also show these information by
pressing DISPLAY on the remote control. (See page 14.)
1
Press MENU (or MENU/EXIT on the
remote control) to display the Main
Menu.
2
Press 5/∞ to move the cursor (3) to
“STATUS DISPLAY.”
3
Press 3 to display the current input
terminal and received signal type.
Note:
• If you want to make these information appear automatically
when you change the input mode, see “Showing the
On-screen When Changing the Input Mode” on page 25.
Input selected
P I C T U R E A D J .
S I Z E / P O S I T I O N A D J .
F U N C T I O N S E L E C T
S T A T U S D I S P L A Y
E N T E R :
M A I N M E N U
S E L E C T : E X I T : M E N U
Cursor ( 3)
Ex. When selecting “RGB A” or “RGB B” input VOLUME –
VIDEO
DISPLAY
OFF POWER
RM–C579 REMOTE CONTROL UNIT
ON
ASPECT
MUTING
MENU/EXIT
VOLUME
A
COMPO.
/(RGB B)
B RGB A
INPUT SELECT
2 / 3
5 / 5
MENU/EXIT
* 1
For GM-V42PCE, GM-V42PCEG and GM-V42PCEB:
“REMOTE SWITCH” does not appear on the menu
unless the video input unit (IF-C42P1G) is separately
purchased and installed.
MENU INPUT
MENU INPUT
MENU 2 / 3
5
5 /
24_33_GM_V42[E].p65 03.6.23, 4:43 PM 24