JVC LPT1056-001A - Manual (Page 38)

38
Troubleshooting (Continued)
Symptom Cause Correction
The DVD+VCR does not
start playback. • An unplayable disc is inserted. • Insert a playable disc. (Check the disc
type and Regional code.)
• The disc is placed upside down. • Place the disc with the playback side
down.
• The disc is not placed within the guide. • Place the disc on the disc tray correctly
inside the guide.
• The disc is dirty. • Clean the disc.
• The Rating level is set. • Cancel the Rating function or change
the rating level.
Video tape cannot be
inserted. • Is the cassette compartment empty? • Eject the tape in.
No Hi-Fi sound • Audio mode is not set properly. • Select STEREO by repeatedly pressing
AUDIO on the remote control.
No NICAM sound
recording • NICAM mode is not set properly. • Make sure NICAM in the menu is set to
AUTO for the station to be recorded.
The remote control does
not work properly. • There is an obstacle in the path of the
remote control and this unit.
• Remove the obstacle.
• The batteries in the remote control are
exhausted.
• Replace the batteries with new ones.
• The remote control is not pointed at the
remote sensor of the DVD+VCR.
• Point the remote control at the remote
sensor of the DVD+VCR.
• The remote control is too far from the
DVD+VCR.
• Operate the remote control within 23ft
(7 m).
• This remote control use the same buttons
for VCR and DVD functions (ex.PLAY).
• When using a VCR, first press the VCR
button. When using a DVD, first press
the DVD button.
Timer recording is not
possible. • Clock in DVD+VCR is not set to correct
time.
• Set clock to correct time.
• Timer has been programmed incorrectly. • Reprogram Timer.
• indicator light does not appear after
programming timer.
• Reprogram Timer and turn DVD+VCR
off to enable timer.
VJ9033CP1Z_E-EZ.book Page 38 Friday, March 11, 2005 10:12 AM