Sony Qualia 006 - Manual (Page 66)

Using the Remote Control
64
SXRD
2-584-141-12(1)
Programming the Remote Control
The remote control is preset to operate Sony brand video equipment.
If you have video equipment other than Sony brand that you want to control
with the SXRD projection TV’s remote control, use the following procedure
to program the remote control.
1
Turn to the list of “Manufacturer’s Codes” on page 65, and find the
three-digit code number for the manufacturer of your equipment. (If
more than one code number is listed, use the number listed first.)
2
Press FUNCTION repeatedly until the DVD/VCR, SAT/CABLE or
i.LINK indicator lights up.
3
Press SAT/CABLE for five seconds until the indicator of the selected
input flashes.
4
While the desired indicator is flashing, enter the three-digit
manufacturer’s code number.
5
Press ENTER .
6
To check if the code number works, aim the SXRD projection TV’s
remote control at the equipment and press
SAT/CABLE that
corresponds with that equipment. If it responds, you are done. If not, try
using another code listed for that manufacturer.
Function Equipment Programmable Code
Number
DVD/VCR Sony DVD player 751
SAT/CABLE Sony Satellite Receiver 801
i.LINK Sony DVD player (i.LINK) 901
✍
The equipment must have infrared (IR) remote capability in order to be
used with the remote control.
✍
You must do step 5 within 10 seconds of step 4, or you must redo
steps 4 through 5.
✍
If more than one code number is listed, try entering them one by one
until you come to the correct code for your equipment.
✍
If you enter a new code number, the code number you previously entered
at that setting is erased.
✍
In some cases, you may not be able to operate your equipment with the
supplied remote control. In such cases, use the equipment’s own remote
control unit.
✍
Whenever you remove the batteries to replace them, the code numbers
may revert to the factory setting and must be reset.