SINGER ESP 2 - Manual (Page 9)

STEAM BURST STEAM BURST
1.Hold Pressing Plate approximately 3" above Ironing Board. 1.Hold Pressing Plate approximately 3" above Ironing Board.
2.Press Steam Burst Button to release a burst of steam onto fabric.
2.Press Steam Burst Button to release a burst of steam onto fabric.
3.Lowr Pressing Plate onto fabric, then raise once again.
3.Lowr Pressing Plate onto fabric, then raise once again.
4.Repeat steps 1-3 above until fabric is smooth and wrinkle-free.
4.Repeat steps 1-3 above until fabric is smooth and wrinkle-free.
IMPORTANT NOTE IMPORTANT NOTE
FOR BEST RESULTS, PRESS BUTTON FOR 2 SECONDS AND RELEASE. FOR BEST RESULTS, PRESS BUTTON FOR 2 SECONDS AND RELEASE.
STEAMING TIPS STEAMING TIPS
Pressing Garments Pressing Garments
1. Lay the garment on the Ironing Board. 1. Lay the garment on the Ironing Board.
2. Lower the steam plate and return to the open position after a few seconds.
2. Lower the steam plate and return to the open position after a few seconds.
NOTE: the unit will automatically turn off the heating plate after
NOTE: the unit will automatically turn off the heating plate after
10 seconds in the closed position. A beep will emit until the unit is opened.
10 seconds in the closed position. A beep will emit until the unit is opened.
Once the unit is opened, it will return to normal operation.
Once the unit is opened, it will return to normal operation.
Wrinkle Removal Wrinkle Removal
1. Lower the Steam Plate until it is slightly above the Ironing Board(about three inches). 1. Lower the Steam Plate until it is slightly above the Ironing Board(about three inches).
2.Activate the Burst of Steam with the buttons on the sides of the Pressing Handle.
2.Activate the Burst of Steam with the buttons on the sides of the Pressing Handle.
3.Wait a few seconds, and activate the Burst of Steam again.
3.Wait a few seconds, and activate the Burst of Steam again.
8 8
TIPS PRESSING TIPS PRESSING